TROUBLESHOOTING
PROBLEM | PROBABLE CAUSE | CORRECTION |
Engine will not | 1. Fuel tank is empty. | 1. | Fill fuel tank. | |
crank/start. | 2. | Fuel | 2. | Open fuel |
| ||||
| 3. | Build up of dirt and residue around | 3. | Clean area around governor/carburetor. |
|
| governor/carburetor. |
|
|
| 4. | Key Switch not in run position. | 4. | Put Key Switch into run position. |
|
|
| ||
| 5. | Electric starter not functioning. | 5. | Check for a bad starter or connections. |
|
|
| ||
|
|
|
| |
Engine stops. | 1. Out of fuel. | 1. | Fill fuel tank. | |
| 2. | Fuel | 2. | Open fuel |
| 3. | Mechanical jam in blower rake or | 3. | Turn off engine, remove key, and wait for |
|
| impeller. |
| all moving parts to stop. Check for and |
|
|
|
| remove obstruction and repair before |
|
|
|
| restart. |
| 4. | Polluted fuel supply. | 4. | Replace with clean fuel. |
| 5. | Faulty spark plug. | 5. | Replace or clean spark plug. |
|
|
|
| |
Engine problems. | 1. See Engine Manual. |
|
| |
|
|
|
| |
Does not operate in | 1. Friction disc not adjusted properly. | 1. | Repair or replace friction disc. See | |
Forward / Reverse. |
|
|
| Friction Disc Replacement on page 23. |
| 2. | Traction belt not functioning. | 2. | Repair or replace traction drive belt. See |
|
|
|
| Traction Drive Belt Replacement on |
|
|
|
| page 21. |
| 3. | Speed selector not adjusted | 3. | Adjust speed selector. See Speed |
|
| properly. |
| Selector Adjustment on page 19. |
|
|
|
| |
Small rubber beads | 1. Friction disc wear. | 1. | Normal friction disc wear. Chunks or | |
collect in frame |
|
|
| large pieces of rubber mean friction disc |
|
|
|
| should be checked and replaced as |
|
|
|
| necessary. |
|
|
|
| |
Unit throws snow | 1. Shear bolts broken. | 1. | Replace shear bolts (see Shear Bolts on | |
poorly or does not |
|
|
| page 18). |
throw snow. | 2. | Attachment clutch/brake not | 2. | Adjust attachment clutch/brake (see |
| ||||
|
| Attachment Clutch/Brake Adjustment on | ||
|
| adjusted properly. |
| |
|
|
| page 21). | |
|
|
|
| |
| 3. | Auger is frozen in place. | 3. | Move unit to a warm place to thaw. |
|
|
| ||
| 4. | Ice or debris is obstructing auger. | 4. | With the engine off and auger |
|
| disengaged, check for obstructions and | ||
|
|
|
| |
|
|
|
| remove. |
| 5. | Attachment drive belt slipping, | 5. | Adjust or replace attachment drive belt |
|
| (see Attachment Clutch/Brake | ||
|
| worn or damaged. |
| |
|
|
| Adjustment on page 21). | |
|
|
|
|
GB - 26