GB Assembly Instructions
■Caution: While assembly of the product keep off children’s reach (Choking hazard - con- tains small parts).
How to handle the swing
■Make sure that usage does not commence until the apparatus has been properly assem- bled and subsequently controlled by an adult.
■Instruct children on the proper handling of the apparatus and advise them of possible dangers.
■Remember that the children's natural play instinct and temper may lead to unforeseeable situations excluding a responsibility of the manufacturers.
■Although dangers to children during proper use of the apparatus are highly unlikely, all play on the apparatus should be monitored by an adult.
■For cleaning and caring the swing only use environmentally friendly and no aggressive or corroding agents.
■Regularly grease the moving parts with some drops of oil.
Instructions for Assembly
■Ensure that you have received all the parts required (see check list) and that they are un- damaged. Should you have any cause for complaint, please contact your KETTLER dealer.
■Before assembling the equipment, study the drawings carefully and carry out the operati- ons in the order shown by the diagrams. The correct sequence is given in capital letters.
■The fastening material required for each assembly step is shown in the diagram inset. Use the fastening material exactly as instructed. The required tools are supplied with the equip- ment.
■The equipment must be assembled with due care by an adult person. If in doubt call upon the help of a second person, if possible technically talented.
■Please note that there is always a danger of injury when working with tools or doing ma- nual work. Therefore please be careful when assembling this machine.
■Ensure that your working area is free of possible sources of danger, for example don’t lea- ve any tools lying around. Always dispose packaging material in such a way that it may not cause any danger. There is always a risk of suffocation if children play with plastic bags!
■Bolt all the parts together loosely at first, and check that they have been assembled cor- rectly. Tighten the locknuts by hand until resistance is felt, then use spanner to finally tigh- ten nuts completely against resistance (locking device). Then check that all screw connec- tions have been tightened firmly. Attention: once locknuts have been unscrewed they no longer function correctly (the locking device is destroyed), and must be replaced.
■For technical reasons, we reserve the right to carry out preliminary assembly work (e.g. addition of tubing plugs).
6