Nortel Networks 8000, 5399 quick start Related Publications

Page 10

Quick-Start Guide for Nortel Networks 5399 and 8000 Access Switches

Related Publications

For more information about using the Model 5399 and Model 8000 Remote Access Concentrators, refer to the following publications:

•Nortel Networks 5399 Access Switch Hardware Installation Guide (Nortel Networks part number 308679-A)

•Installing the Nortel Networks 8000 Access Switch (Nortel Networks part number 308680-A)

•Nortel Networks 5399 and 8000 Access Switch SNMP MIB Reference (Nortel Networks part number 300861-C)

•Nortel Networks 5399 and 8000 Access Switch Software Reference (Nortel Networks part number 300860-C)

•Installing and Configuring Access Switch Software for UNIX (Nortel Networks part number 300856-C)

•Installing and Administering the Config Utility (Nortel Networks part number 301697-C)

•Installing and Configuring Nortel Networks 5399 and 8000 Access Switch Software for Windows and Windows NT (Nortel Networks part number 300857-C)

•Provisioning WAN Lines for Nortel Networks 5399 and 8000 Access Switches (Nortel Networks part number 300854-C)

You can print selected technical manuals and release notes free, directly from the Internet. Go to support.baynetworks.com/library/tpubs/. Find the product for which you need documentation. Then locate the specific category and model or version for your hardware or software product. Using Adobe Acrobat Reader, you can open the manuals and release notes, search for the sections you need, and print them on most standard printers. You can download Acrobat Reader free from the Adobe Systems Web site, www.adobe.com.

x

300855-C Rev. 00

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Page Restricted Rights Legend Copyright 1999 Nortel NetworksTrademarks Statement of ConditionsIii Rev.00 Contents Page Preface Before You BeginText Conventions Acronyms Related Publications How to Get Help Technical Solutions Center Telephone NumberPage Quick-Start Guide Quick-Start TasksQuick-Start Tasks Order Line Provisioning Task 1 Site PreparationIP Addresses Boot Sequence Task 2 Install RAC SoftwareTask 3 Install the RAC Software ImageEnter r slot number to reset Task 4 RAC ConfigurationPress the space bar to enter monitor mode Set the Network Addresses Set the Operating Image Configure the Interface SequenceAt the ROM monitor prompt, enter seq. The system responds Task 5 Boot the RAC Enable the allowsnmpsets ParameterTask 6 Configure the Switch Type Admin set wan=1 switchtype AT9Task 8 Configure Security Task 7 Set Switch ParametersACP Security Set the RAC’s ACP host Set vcli securityRadius Security Configure the Radius host Set the RAC’s Radius hostSet the RAC’s accounting host PPP Setup Reboot the RAC for the configuration changes to take effectSet PPP security protocol Roadmap Task 9 Reboot the RACSet up the RAC so that addresses are on the DS0s Task 10 Customizing the RACInstalling and Configuring the RAC Task DocumentationTask Tools and Documentation Customizing the RAC Windows NTRAC Reference Documentation Quick-Start Guide
Top Page Image Contents