Nortel Networks 5399, 8000 quick start Acronyms

Page 9

 

Preface

 

 

italic text

Indicates file and directory names, new terms, book

 

titles, and variables in command syntax descriptions.

 

Where a variable is two or more words, the words are

 

connected by an underscore.

 

Example: If the command syntax is:

 

show at <valid_route>

 

valid_route is one variable and you substitute one value

 

for it.

screen text

Indicates system output, for example, prompts and

 

system messages.

 

Example: Set Trap Monitor Filters

Acronyms

This guide uses the following acronyms:

ANI

Automatic Number Identification

CAS

Channel Associated Signaling

DNIS

Dialed Number Information Service

FDL

Facilities Data Link

ISDN

Integrated Services Digital Network

PRI

Primary Rate ISDN

RAC

Remote Access Concentrator

WAN

Wide Area Network

300855-C Rev. 00

ix

Image 9
Contents Page Trademarks Copyright 1999 Nortel NetworksRestricted Rights Legend Statement of ConditionsIii Rev.00 Contents Page Before You Begin PrefaceText Conventions Acronyms Related Publications Technical Solutions Center Telephone Number How to Get HelpPage Quick-Start Tasks Quick-Start GuideQuick-Start Tasks Task 1 Site Preparation Order Line ProvisioningIP Addresses Task 3 Install the RAC Task 2 Install RAC SoftwareBoot Sequence Software ImageTask 4 RAC Configuration Enter r slot number to resetPress the space bar to enter monitor mode Set the Network Addresses Configure the Interface Sequence Set the Operating ImageAt the ROM monitor prompt, enter seq. The system responds Enable the allowsnmpsets Parameter Task 5 Boot the RACAdmin set wan=1 switchtype AT9 Task 6 Configure the Switch TypeTask 7 Set Switch Parameters Task 8 Configure SecurityACP Security Set vcli security Set the RAC’s ACP hostConfigure the Radius host Set the RAC’s Radius host Radius SecuritySet the RAC’s accounting host Reboot the RAC for the configuration changes to take effect PPP SetupSet PPP security protocol Set up the RAC so that addresses are on the DS0s Task 9 Reboot the RACRoadmap Task 10 Customizing the RACTask Documentation Installing and Configuring the RACTask Tools and Documentation Windows NT Customizing the RACRAC Reference Documentation Quick-Start Guide