Nortel Networks 5399, 8000 quick start

Page 1

Version 8.0

Part No. 300855-C Rev.00

December 1999

4401 Great America Parkway

Santa Clara, CA 95054

Quick Start Guide for Nortel Networks 5399 and 8000 Access Switches

Image 1

Contents Page Trademarks Copyright 1999 Nortel NetworksRestricted Rights Legend Statement of ConditionsIii Rev.00 Contents Page Before You Begin PrefaceText Conventions Acronyms Related Publications Technical Solutions Center Telephone Number How to Get HelpPage Quick-Start Tasks Quick-Start GuideQuick-Start Tasks Order Line Provisioning Task 1 Site PreparationIP Addresses Task 3 Install the RAC Task 2 Install RAC SoftwareBoot Sequence Software ImageEnter r slot number to reset Task 4 RAC ConfigurationPress the space bar to enter monitor mode Set the Network Addresses Set the Operating Image Configure the Interface SequenceAt the ROM monitor prompt, enter seq. The system responds Enable the allowsnmpsets Parameter Task 5 Boot the RACAdmin set wan=1 switchtype AT9 Task 6 Configure the Switch TypeTask 8 Configure Security Task 7 Set Switch ParametersACP Security Set vcli security Set the RAC’s ACP hostRadius Security Configure the Radius host Set the RAC’s Radius hostSet the RAC’s accounting host PPP Setup Reboot the RAC for the configuration changes to take effectSet PPP security protocol Set up the RAC so that addresses are on the DS0s Task 9 Reboot the RACRoadmap Task 10 Customizing the RACTask Documentation Installing and Configuring the RACTask Tools and Documentation Windows NT Customizing the RACRAC Reference Documentation Quick-Start Guide