Nortel Networks 5399, 8000 quick start Quick-Start Guide, Quick-Start Tasks

Page 13

Quick-Start Guide

This Quick-Start guide describes how to install and configure Remote Access Concentrator (RAC) hardware and software using factory defaults. After installing the RAC, you can customize it for your specific requirements.

This guide is written for system administrators who install and maintain RACs and have knowledge of networking and networking protocols. You can choose either the quick-start procedure or the roadmap.

The information is presented as follows:

Quick-Start -- Provides summarized instructions for installing the software images, tools, and the RAC.

Roadmap -- Lists tasks and related documentation for each task.

Related Documentation -- Lists all documents supporting Remote Access Concentrators.

Quick-Start Tasks

The quick-start tasks are designed to provide the information necessary to install and configure the RACs using factory defaults. Table 1 summarizes the quick-start tasks.

300855-C Rev. 00

1

Image 13
Contents Page Trademarks Copyright 1999 Nortel NetworksRestricted Rights Legend Statement of ConditionsIii Rev.00 Contents Page Before You Begin PrefaceText Conventions Acronyms Related Publications Technical Solutions Center Telephone Number How to Get HelpPage Quick-Start Tasks Quick-Start GuideQuick-Start Tasks Order Line Provisioning Task 1 Site PreparationIP Addresses Task 3 Install the RAC Task 2 Install RAC SoftwareBoot Sequence Software ImageEnter r slot number to reset Task 4 RAC ConfigurationPress the space bar to enter monitor mode Set the Network Addresses Set the Operating Image Configure the Interface SequenceAt the ROM monitor prompt, enter seq. The system responds Enable the allowsnmpsets Parameter Task 5 Boot the RACAdmin set wan=1 switchtype AT9 Task 6 Configure the Switch TypeTask 8 Configure Security Task 7 Set Switch ParametersACP Security Set vcli security Set the RAC’s ACP hostRadius Security Configure the Radius host Set the RAC’s Radius hostSet the RAC’s accounting host PPP Setup Reboot the RAC for the configuration changes to take effectSet PPP security protocol Set up the RAC so that addresses are on the DS0s Task 9 Reboot the RACRoadmap Task 10 Customizing the RACTask Documentation Installing and Configuring the RACTask Tools and Documentation Windows NT Customizing the RACRAC Reference Documentation Quick-Start Guide