Nortel Networks 8000, 5399 Task 7 Set Switch Parameters, Task 8 Configure Security, ACP Security

Page 22

Quick-Start Guide for Nortel Networks 5399 and 8000 Access Switches

Task 7: Set Switch Parameters

Using the switch parameters gathered from Task1, configure the switch.

View the existing WAN parameters by entering sho wan=all all. Set the WAN parameters to be compatible with those provided by the telco. For information on setting WAN parameters, refer to Managing Nortel Networks 5399 and 8000 Access Switches Using Command Line Interfaces.

Note: Make sure the WAN parameters are compatible with those provided by the telco. The telco may temporarily disable lines connected to improperly configured devices. For more information on WAN parameters, refer to Nortel Networks 5399 and 8000 Access Switch Software Reference.

Task 8: Configure Security

This section describes how to configure both ACP and RADIUS security regimes and PPP setup. When configuring RAC security, you configure the security regime before configuring PPP.

Note: If you are using another third party security regime, refer to the Managing Nortel Networks 5399 and 8000 Access Switches Using Command Line Interfaces and Installing and Administering the Config Utility.

ACP Security

This section tells the user how to configure ACP security on a server and how to setup the RAC to authenticate users. After setting up security on a Microsoft NT server or a UNIX server, you must setup the RAC for authentication on the server.

Note: To configure ACP security, you must have selected ACP as the default security regime during the software installation.

10

300855-C Rev. 00

Image 22
Contents Page Restricted Rights Legend Copyright 1999 Nortel NetworksTrademarks Statement of ConditionsIii Rev.00 Contents Page Preface Before You BeginText Conventions Acronyms Related Publications How to Get Help Technical Solutions Center Telephone NumberPage Quick-Start Guide Quick-Start TasksQuick-Start Tasks Order Line Provisioning Task 1 Site PreparationIP Addresses Boot Sequence Task 2 Install RAC SoftwareTask 3 Install the RAC Software ImageEnter r slot number to reset Task 4 RAC ConfigurationPress the space bar to enter monitor mode Set the Network Addresses Set the Operating Image Configure the Interface SequenceAt the ROM monitor prompt, enter seq. The system responds Task 5 Boot the RAC Enable the allowsnmpsets ParameterTask 6 Configure the Switch Type Admin set wan=1 switchtype AT9Task 8 Configure Security Task 7 Set Switch ParametersACP Security Set the RAC’s ACP host Set vcli securityRadius Security Configure the Radius host Set the RAC’s Radius hostSet the RAC’s accounting host PPP Setup Reboot the RAC for the configuration changes to take effectSet PPP security protocol Roadmap Task 9 Reboot the RACSet up the RAC so that addresses are on the DS0s Task 10 Customizing the RACInstalling and Configuring the RAC Task DocumentationTask Tools and Documentation Customizing the RAC Windows NTRAC Reference Documentation Quick-Start Guide