Nortel Networks 5399, 8000 quick start Preface, Before You Begin

Page 7

Preface

If you are responsible for installing, configuring, or managing a Nortel Networks 5399 Access Switch or 8000 Access Switch (formerly known as Model 5399 and Model 8000 Remote Access Concentrator (RAC)), you need to read this guide.

Note: The Access Switch product name appears only on the title page. Whenever the term Remote Access Concentrator (RAC) appears in this document, it refers to the Nortel Networks 5399 or 8000 Access Switch.

This guide provides instructions for installing Nortel Networks Remote Access Concentrator (RAC) hardware and software.

Before You Begin

Before using this guide, you must order line provisioning through your telco. For more information, refer to Provisioning WAN Lines for Nortel Networks 5399 and 8000 Access Switches.

300855-C Rev. 00

vii

Image 7
Contents Page Statement of Conditions Copyright 1999 Nortel NetworksTrademarks Restricted Rights LegendIii Rev.00 Contents Page Before You Begin PrefaceText Conventions Acronyms Related Publications Technical Solutions Center Telephone Number How to Get HelpPage Quick-Start Tasks Quick-Start GuideQuick-Start Tasks Order Line Provisioning Task 1 Site PreparationIP Addresses Software Image Task 2 Install RAC SoftwareTask 3 Install the RAC Boot SequenceEnter r slot number to reset Task 4 RAC ConfigurationPress the space bar to enter monitor mode Set the Network Addresses Set the Operating Image Configure the Interface SequenceAt the ROM monitor prompt, enter seq. The system responds Enable the allowsnmpsets Parameter Task 5 Boot the RACAdmin set wan=1 switchtype AT9 Task 6 Configure the Switch TypeTask 8 Configure Security Task 7 Set Switch ParametersACP Security Set vcli security Set the RAC’s ACP hostRadius Security Configure the Radius host Set the RAC’s Radius hostSet the RAC’s accounting host PPP Setup Reboot the RAC for the configuration changes to take effectSet PPP security protocol Task 10 Customizing the RAC Task 9 Reboot the RACSet up the RAC so that addresses are on the DS0s RoadmapTask Documentation Installing and Configuring the RACTask Tools and Documentation Windows NT Customizing the RACRAC Reference Documentation Quick-Start Guide