Nortel Networks 5399, 8000 Reboot the RAC for the configuration changes to take effect, PPP Setup

Page 25

Quick-Start Guide

7.Leave cli security off so you can access the RAC from the console. admin: set port cli_security n

8.Set vcli security.

admin: set annex vcli_security y

9.Reboot the RAC for the configuration changes to take effect.

admin: quit

annex# boot

10.After the RAC is rebooted, try to log on to the RAC through a telnet session. If security is working you may go ahead and set cli security using the following admin command:

admin: set port cli_security y

PPP Setup

To set up PPP security, perform the following:

1.Log on to the RAC as superuser and run admin.

2.Set PPP security.

admin: set port slip_ppp_security y

3.Set PPP security protocol.

admin: set port ppp_security_protocol <security protocol> (pap or chap)

4.Enable security for terminal dial-in users. admin: set port cli_security y

5.Set the RAC for PPP callers only. admin: set port mode ppp admin: reset port

300855-C Rev. 00

13

Image 25
Contents Page Trademarks Copyright 1999 Nortel NetworksRestricted Rights Legend Statement of ConditionsIii Rev.00 Contents Page Before You Begin PrefaceText Conventions Acronyms Related Publications Technical Solutions Center Telephone Number How to Get HelpPage Quick-Start Tasks Quick-Start GuideQuick-Start Tasks Order Line Provisioning Task 1 Site PreparationIP Addresses Task 3 Install the RAC Task 2 Install RAC SoftwareBoot Sequence Software ImageEnter r slot number to reset Task 4 RAC ConfigurationPress the space bar to enter monitor mode Set the Network Addresses Set the Operating Image Configure the Interface SequenceAt the ROM monitor prompt, enter seq. The system responds Enable the allowsnmpsets Parameter Task 5 Boot the RACAdmin set wan=1 switchtype AT9 Task 6 Configure the Switch TypeTask 8 Configure Security Task 7 Set Switch ParametersACP Security Set vcli security Set the RAC’s ACP hostRadius Security Configure the Radius host Set the RAC’s Radius hostSet the RAC’s accounting host PPP Setup Reboot the RAC for the configuration changes to take effectSet PPP security protocol Set up the RAC so that addresses are on the DS0s Task 9 Reboot the RACRoadmap Task 10 Customizing the RACTask Documentation Installing and Configuring the RACTask Tools and Documentation Windows NT Customizing the RACRAC Reference Documentation Quick-Start Guide