Nortel Networks 5399, 8000 Task 6 Configure the Switch Type, Admin set wan=1 switchtype AT9

Page 21

Quick-Start Guide

Task 6: Configure the Switch Type

You must configure the switch type using the information collected in Task 1 before connecting the network cables to the WAN ports. To configure the switch type:

1.After the RAC boots, enter cli at the console monitor prompt. (If you are configuring a 5399, connect to the slot the 5399 is installed in using the Slot Selection menu before entering the cli command.)

2.Enter admin as follows:

annex: su

Password:

Note: The default password is the RAC’s IP address.

Annex# admin

3.Using the set wan command, enter the switch type. The example below shows how you set the switch for AT9. Enter the switch type from the telco information. (For more information about switch types, refer to Provisioning WAN Lines for Nortel Networks 5399 and 8000 Access Switches.)

admin: set wan=1 switch_type AT9

You may need to reset the appropriate port,

Annex subsystem or reboot the Annex for changes

to take effect.

This sets the switch type for interface 1 to AT9. To specify WAN 2, enter wan=2; for both WANs, enter wan=all

300855-C Rev. 00

9

Image 21
Contents Page Trademarks Copyright 1999 Nortel NetworksRestricted Rights Legend Statement of ConditionsIii Rev.00 Contents Page Before You Begin PrefaceText Conventions Acronyms Related Publications Technical Solutions Center Telephone Number How to Get HelpPage Quick-Start Tasks Quick-Start GuideQuick-Start Tasks Task 1 Site Preparation Order Line ProvisioningIP Addresses Task 3 Install the RAC Task 2 Install RAC SoftwareBoot Sequence Software ImageTask 4 RAC Configuration Enter r slot number to resetPress the space bar to enter monitor mode Set the Network Addresses Configure the Interface Sequence Set the Operating ImageAt the ROM monitor prompt, enter seq. The system responds Enable the allowsnmpsets Parameter Task 5 Boot the RACAdmin set wan=1 switchtype AT9 Task 6 Configure the Switch TypeTask 7 Set Switch Parameters Task 8 Configure SecurityACP Security Set vcli security Set the RAC’s ACP hostConfigure the Radius host Set the RAC’s Radius host Radius SecuritySet the RAC’s accounting host Reboot the RAC for the configuration changes to take effect PPP SetupSet PPP security protocol Set up the RAC so that addresses are on the DS0s Task 9 Reboot the RACRoadmap Task 10 Customizing the RACTask Documentation Installing and Configuring the RACTask Tools and Documentation Windows NT Customizing the RACRAC Reference Documentation Quick-Start Guide