6.Set up the RAC so that addresses are on the DS0s.
admin: wan 1
admin: set wan=1 ds0=all remote_address <starting ip address> 1
admin: reset wan
Note: IP addresses are incremented from the starting IP address using an increment of 1. Addresses will be applied on all DS0s and will be used at random as the DS0s are used at random. Addresses are assigned to users once they dial in.
Task 9: Reboot the RAC
After making all the configuration changes, you must reboot the RAC for the changes to take effect. After you reboot the RAC:
1.Connect the cables to the WAN interface ports on the front (Model 5399) or back (Model 8000) of the RAC.
2.Test the RAC by dialing into it.
Task 10: Customizing the RAC
After installing and booting the RAC, you can customize RAC parameters (for example security or port parameters) using one of the following tools:
•CLI interface (see Managing Nortel Networks 5399 and 8000 Access Switches Using Command Line Interfaces)
•Config Utility (see Installing and Administering the Config Utility and the Config Utility online Help system)
Roadmap
The roadmap provides a series of tasks that you must perform in sequential order to install, configure, and boot a RAC. Refer to the specified documentation for detailed instructions. The roadmap can be divided into two distinct sections: installation and configuration, and customization.
14 |