ViewSonic PJ400 manual Setup menu, Normal Whisper, Normal Hinvert Vinvert H&VINVERT, Volume

SETUP menu

With the SETUP menu, items shown in the table below can be performed.

Choose an item using the cursor buttons ▲/▼ on the projector or remote control, and press the cursor button ► on the projector or remote control, or the ENTER button on the remote control to progress. Then perform it referring to the following table.

Item		Description
ZOOM	Using the buttons ▲/▼ adjusts the zoom (magnifying power).
	Large ↔ Small
KEYSTONE	Using the buttons ▲/▼ corrects the keystone distortion.
	Upper in the data ↔ Lower in the data
	• The adjustable range of this function will vary with the type of
	input signal. At some signals, this function may not work well.
	• When the V:INVERT or the H&V:INVERT is selected under
	the item MIRROR, if the projector screen is inclined or if the
	projector is angled downward, this function may not work
	correctly.
	• When the zoom adjustment is set to the TELE side, this
	correction may be excessive. This function should be used with
	zoom set to WIDE whenever possible.
WHISPER	Using the buttons ▲/▼ turns off/on the whisper mode.
	NORMAL	WHISPER
	• When the WHISPER is selected, acoustic noise and screen
	brightness are reduced.
MIRROR	Using the buttons ▲/▼ switches the mode for mirror status.
	NORMAL	H:INVERT V:INVERT H&V:INVERT
	════=══=══=══=══=══=══=════
VOLUME	Using the buttons ▲/▼ adjusts the volume.
	High ↔ Low

ViewSonic PJ400 34