Eiki LC-XB27 owner manual Remote Control Battery Installation, Operating Range, Adjustable Feet

Part Names and Functions

Remote Control Battery Installation

1	Open the battery	2	Slide the batteries into
	compartment lid.		the compartment.
	Press the lid		Two AAA size
	downward and slide it.		batteries
			For correct polarity (+
			and –), be sure
			battery terminals are
			in contact with pins
			in compartment.

Replace the

3 compartment lid.

Part Names and Functions

To insure safe operation, please observe the following precautions :

●Use (2) AAA,UM-04 or LR03 type alkaline batteries.

●Always replace batteries in sets.

●Do not use a new battery with a used battery.

●Avoid contact with water or liquid.

●Do not expose the remote control to moisture, or heat.

●Do not drop the remote control.

●If the battery has leaked on the remote control, carefully wipe case clean and install new batteries.

●Risk of an explosion if battery is replaced by an incorrect type.

●Dispose of used batteries according to the instructions.

Operating Range

Point the remote control toward the projector (Infrared Remote Receiver) whenever pressing any button. Maximum operating range for the remote control is about 16.4’ (5m) and 60° in front of the projector.

16.4’ (5 m)

60° Remote control

Adjustable Feet

Projection angle can be adjusted up to 10.0 degrees with the adjustable feet.

1	Lift the front of the projector and pull upward the feet
	lock latches on both sides of the projector.
2	Release the feet lock latches to lock the adjustable
	feet and rotate the adjustable feet to adjust the
	position and tilt.
3	Keystone distortion of the projected image can be
	adjusted automatically with Auto setup function or

manually with the remote control or the menu operation. (p25, 46, 47)

Feet Lock Latches

Adjustable Feet

15