Eiki LC-XB27 owner manual Connecting to a Computer, Cables used for connection

Installation

Connecting to a Computer

Cables used for connection

•VGA Cable (Mini D-sub 15 pin) ✽ •DVI-VGA Cable

•USB Cable

•Audio Cables ✽

(✽ = Not supplied with this projector.)

Monitor Output

Audio Output USB port Monitor Output orExternal Audio Equipment Monitor Input

USB cable DVI-VGA cable

Audio Input

VGA cable ✽

Audio cable (stereo) ✽

		COMPUTER IN 2
USB	COMPUTER IN 1/
	DVI-I	/COMPONENT IN
		/MONITOR OUT
			This terminal is switchable. Set up the
			terminal as either Computer input or
			Monitor output. (See Page 50.)

Audio cable ✽ (stereo)

						(VARIABLE)
				COMPUTER IN 2	R	AUDIO OUT	AUDIO OUT
RESET	USB	SERVICE PORT	COMPUTER IN 1	/ COMPONENT IN			(stereo)
			DVI-I	MONITOR OUT
				VIDEO IN	L	COMPUTER /
				S-VIDEO IN	(MONO)	COMPONENT
					AUDIO IN
	C O M P U T E R /
	COMPONENT
	AUDIO IN

✔Note:
•Input sound to the COMPUTER / COMPONENT AUDIO IN
terminal when using the COMPUTER IN 1 / DVI-I and the	When connecting the cable, the power
COMPUTER IN 2 / COMPONENT IN / MONITOR OUT terminal	cords of both the projector and the
as input.	external equipment should be
• When connecting the AUDIO OUT to external audio equipment,	disconnected from AC outlet.
the projector's built-in speaker is disconnected.

•When the cable is of the longer variety, it ONis advisableONto use the COMPUTER IN 1 / DVI-I and not the COMPUTER IN 2 /

COMPONENT IN / MONITOR OUT.

•USB cable connection is needed when operating the computer with the remote control or using the PAGE ed buttons on the remote control.

18