Eiki LC-XB27 owner manual Video Input, Input Source Selection Video, S-video, Auto

Video Input

Input Source Selection (Video, S-video)

Direct Operation

Choose Video by pressing the INPUT button on the top control or the VIDEO button on the remote control.

Before using these buttons, correct input source should be selected through menu operation as described below.

Top Control

	POWER	WARNING	LAMP R
ON	MENU	INPUT	AUTO
			S
-			ET
OFF
	SELECT
			+
-V			V

INPUT button

INPUT button

Computer 1

(Analog/Digital)

Computer 2 ✳

Video

Wired

✳See Note at the bottom of this page.

		Remote Control
Menu Operation		VIDEO button
1	Press the MENU button to display the On-Screen
	Menu. Press the Point 7 8 buttons to move the red	Input Menu icon
	framed pointer to the Input Menu icon.
		Input Menu
2	Press the Point ed buttons to move the red arrow
	pointer to Video and then press the SELECT button to	Move the pointer
	display the Source Select Menu .
		to Video and press
		the SELECT
3		button.
	Move the pointer to the source that you want to select
	and then press the SELECT button.

Auto

When selecting Auto, the projector automatically detects incoming video signal, and adjusts itself to optimize its performance. The projector selects connection in the following order:

1.S-video

2.Video

VIDEO

Source Select Menu (VIDEO)

Move the pointer to the source that you want to select and press the SELECT button.

Video	When video input signal is connected to the
	VIDEO jack, select Video.
	When video input signal is connected to the S-
S-video
	VIDEO jack, select S-video.

✔Note:

•When Monitor out is selected in the Terminal function (p50), Computer 2 is not displayed.

•Wired, Wireless, and Memory Viewer are for the Network function. Refer to the owner's manual "Network Set-up and Operation" supplied with this projector or the owner's manual of Memory viewer (optionally available).

Video Input

39