Computer Input
Input Source Selection (RGB(PC digital), RGB(AV HDCP))
Direct Operation
Choose Computer 1(Digital) by pressing the INPUT button on the top control or press the COMPUTER button on the remote control.
Before using these buttons, correct input source should be selected through Menu operation as described below.
Top Control
| POWER | WARNING LA | |
| MENU | INPUT | AU |
ON |
| ||
- |
|
|
|
OFF |
|
|
|
| SELECT |
|
|
INPUT button
INPUT button
Computer 1
(Analog/Digital)
Computer 2 ✳
Menu Operation
1 Press the MENU button to display the
2 Press the Point ed buttons to move the red arrow pointer to Computer 1(Digital), and then press the SELECT button.
3 After the Source Select Menu appeared for Computer 1(Digital), move the pointer to RGB (PC digital) or RGB (AV HDCP) and then press the SELECT button.
✔Note:
•Computer 2 is not displayed when the COMPUTER IN 2 / COMPONENT IN / MONITOR OUT terminal is set as Monitor out. (p50)
•Computer 2 (COMPUTER IN 2 / COMPONENT IN / MONITOR OUT) can accept only RGB signal.
•HDCP
•Wired, Wireless, and Memory Viewer are for the Network function. Refer to the owner's manual "Network
supplied with this projector or the owner's manual of Memory viewer (optionally available).
Video
Wired
Remote Control
COMPUTER button
COMPUTER button
Computer 1
(Analog/Digital)
Computer 2 ✳
✳See Note at the bottom of this page.
Input Menu icon
Input Menu
Move the pointer (red arrow) to Computer 1 (Digital) and press the SELECT button.
Computer
1
Move the pointer to the source that you want to select and press the SELECT button.
30