Laser Pointer Function, Spotlight Pointer

Part Names and Functions

Laser Pointer Function

This remote control emits a laser beam from the laser light window. With the LASER button pressed, laser light goes on. The signal emission indicator lights red and laser is emitted with red light. With the LASER button pressed for more than 1 minute or released, the light goes off.

The laser emitted is a class II laser. Do not look into the laser light window or shine the laser beam on yourself or other people. Below are the caution labels for laser beam.

CAUTION : Use of controls, adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. Do not look into the laser light window while laser is emitted, otherwise eye damage may result.

These caution labels are put on the remote control.

Signal Emission Indicator

Laser Light Window

Pointer Function

You can move Spotlight or Pointer of the projector with the remote control to emphasize a part of the projected image.

Part Names and Functions

1	With pressing the MENU button, hold down the NO
	SHOW button for more than 10 seconds so that the
	Pointer function will be available. (The Laser pointer
	has switched to the Pointer.)
2	Press the LASER button on the remote control toward
	the projector. Spotlight or Pointer is displayed on the
	screen with the LASER button lighting green. Then
	move the Spotlight or Pointer with the
	PRESENTATION POINTER button. If the LASER
	button does not light green and still emits laser beam,
	try the procedure above until the LASER button lights
	green.
3	To clear the Spotlight or Pointer out the screen, press
	the LASER button toward the projector and see if the

LASER button lighting turns off.

To switch back to the Laser pointer again, hold down the NO SHOW button with pressing the MENU button for more than 10 seconds or slide the RESET/ON/ALL- OFF switch to "RESET". (p12) When you reset the Pointer function, the remote control code will be reset, as well.

Spotlight

Pointer

✔Note:

You can choose the size of Spotlight (Large, Middle, and Small) and the pattern of Pointer (Arrow, Finger, and Dot) in the Setting Menu. See “Pointer” on page 51.

PRESENTATION POINTER button

MENU button

NO SHOW button

While pressing the MENU button, hold down the NO SHOW button for more than 10 seconds.

PRESENTATION POINTER button

LASER button

After the Laser pointer has switched to the Pointer, use the LASER button as the Pointer function ON-OFF switch. Press the LASER button toward the projector and see if it lights green.