Eiki LC-XB27 owner manual Input Source Selection Component, RGB Scart 21-pin

Video Input

Input Source Selection (Component, RGB Scart 21-pin)

Direct Operation

Choose Computer 2 by pressing the INPUT button on the top control or press the COMPUTER button on the remote

Top Control

INPUT button

POWER WARNING LAMP R INPUT button

control.

Before using these buttons, correct input source should be selected through Menu operation as described below.

ON	MENU	INPUT	AUTO
-			SE
OFF
	SELECT
			+
-V			V

Remote Control

Computer 1

(Analog/Digital)

Computer 2

Video

Wired

✳

Menu Operation

1	Press the MENU button to display the On-Screen
	Menu. Press the Point 7 8 buttons to move the red
	framed pointer to the Input Menu icon.
2	Press the Point ed buttons to move the red arrow
	pointer to Computer 2 and then press the SELECT
	button.
3	After the Source Select Menu appeared for Computer
	2, move the pointer to Component or RGB(Scart) and
	then press the SELECT button.
		When the input source is coming from
	Component
		video equipment connected to the
		COMPUTER IN 2 / COMPONENT IN /
		MONITOR OUT terminal with a
		Component-VGA Cable, select Component.

COMPUTER button

COMPUTER button

Computer 1

(Analog/Digital)

Computer 2 ✳

✳See Note at the bottom of this page.

Input Menu Input Menu icon

Move the pointer (red arrow) to Computer 1 and press the SELECT button.

Computer

2

RGB (Scart)

✔Note:

When the input source is coming from video equipment connected to the

COMPUTER IN 2 / COMPONENT IN / MONITOR OUT terminal with a Scart-VGA Cable, select RGB (Scart).

Source Select Menu

Move the pointer to Component or RGB(Scart) and press the SELECT button.

•When Monitor out is selected in the Terminal function (p50), Computer 2 is not displayed.

•Wired, Wireless, and Memory Viewer are for the Network function. Refer to the owner's manual "Network Set-up and Operation" supplied with this projector or the owner's manual of

Memory viewer (optionally available).

40