Computer Input
Input Source Selection (RGB : Computer 1(Analog) / Computer 2 )
Direct Operation
Choose either Computer 1(Analog) or Computer 2 by pressing the INPUT button on the top control or press the COMPUTER button on the remote control.
Before using these buttons, correct input source should be selected through Menu operation as described below.
Top Control
| POWER | WARNING LA | |
| MENU | INPUT | AU |
ON |
| ||
- |
|
|
|
OFF |
|
|
|
| SELECT |
|
|
INPUT button
INPUT button
Computer 1
(Analog/Digital)
Computer 2 ✳
Video
Wired
Remote Control
COMPUTER button
COMPUTER button
Computer 1
(Analog/Digital)
Computer 2 ✳
✳See Note at the bottom of this page.
Menu Operation
1 Press the MENU button to display the
2 Press the Point ed buttons to move the red arrow pointer to either Computer 1(Analog) or Computer 2, and then press the SELECT button.
3 When selecting Computer 1(Analog), RGB input source will be selected directly.
When selecting Computer 2, the Source Select Menu will appear. Move the pointer to RGB and then press the SELECT button.
Input Menu
Input Menu
Input Menu icon
Move the pointer (red arrow) to Computer 1 (Analog) and press the SELECT button.
Input Menu icon
Move the pointer (red arrow) to Computer 2 and press the SELECT button.
Computer Input
✔Note: | Computer |
•Computer 2 is not displayed when the COMPUTER IN 2 / | 2 |
| |
COMPONENT IN / MONITOR OUT terminal is set as Monitor out. |
|
(p50) |
|
•Computer 2 (COMPUTER IN 2 / COMPONENT IN /MONITOR OUT) can accept only RGB signal.
•Wired, Wireless, and Memory Viewer are for the Network function. Refer to the owner's manual "Network
Move the pointer (red arrow) to RGB.
29