Intel 537EX manual Uart, Thr, Rbr

Parallel Host Interface 16C450/16C550A UART

modem for each data interrupt, instead of only a single byte, as in 16C450 mode. The following diagram shows how the FIFO is used. Host software using this FIFO capability can significantly reduce system overhead by reducing the number of times that interrupt service routines are called.

Figure 12. FIFO Buffers for Transmitter and Receiver

Modem		UART
		Transmitter	Host
Transmitter
	Modem Transmitter FIFO	Holding
			(DTE)
Shift
		Register
Register
		(THR)
	UART Transmitter Flow Diagram
Modem		UART
		Receiver	Host
Receiver
	Modem Receiver FIFO	Buffer
Shift			(DTE)
		Register
Register		(RBR)
	UART Receiver Flow Diagram

The register addresses are divided into two types: single-register access and multiple-register access. Most of the UART registers are single-register access (that is, only one internal register is accessible for a given register address). UART register addresses 3–7 are used to access a single internal register. The remainder of the UART register addresses (0–2) are used to access two or more internal registers.

Register address 2 is used to write FIFO control information into the FCR (FIFO Control register) and to read the IIR (Interrupt Identity register).

Register address 1 is used to read and write data to the IER (Interrupt Enable register) [when DLAB = 0] and the MS DLM (Divisor Latch register) [when DLAB = 1].

Register address 0 is used to read data from the RBR (Receiver Buffer register) [when DLAB = 0], write data to the THR (Transmitter Holding register) [when DLAB = 0], and read and write to the LS DLL (Divisor Latch register) [when DLAB = 1]. The UART registers and FIFO usage are described in the following sections.

536EX Chipset Developer’s Manual 93

Intel Confidential