Intel® IQ80219 General Purpose PCI Processor Evaluation Platform
Getting Started and Debugger
C.2 Setup
C.2.1 Hardware Setup
Use Figure 28 and the rest of the Intel® IQ80219 Evaluation Platform Board Manual, to set up the hardware.
•Connect the Raven to the host via the parallel port and to the evaluation board via the
Note: The parallel port must be configured to EPP mode for the Macraigor Raven to work properly.
The parallel port setting can be changed in the BIOS setup program or in Control Panel. More information on the Raven can be found at the Macraigor web site. Test software for the Raven is free and available for download at: http://www.ocdemon.net/Merchant2/merchant.mv?Screen=CTGY&Store_Code=MTS&Category_C ode=pinouts.
•Connect a serial cable from the evaluation board to the host.
Note: The serial cable connects to the evaluation board with an RJ11 connector and connects to the host computer serial port via an RJ11 to DB9F adaptor. The serial port configuration is covered in the configuration section below.
•The IQ80219 plugs into a bus master PCI or
Note: There are many dip switches on the evaluation board which are used to configure the IBM bridge. Use the dip switch and jumper sections of the Intel® IQ80219 Evaluation Platform Board Manual, section
3.10.2to configure these switches. A work sheet is highly recommended when working out the switch settings, Since there are a large number of switches, a record of the settings and the reasons for their selection very useful. Check the system requirements of Microsoft Visual Studio and ATI CodeLab to make sure that the host is sufficient. The platform or backplane must have a 3.3 volt
Figure 30. Intel® IQ80219 Hardware Setup Flow Chart
Host
Serial Cable
JTAG
Evaluation Board
Backplane or
Parallel Port Cable
Board Manual | 107 |