Hardware Installations and Upgrades
Removing a
1.Observe the safety and ESD precautions at the beginning of this book. See “Safety Information.”
2.Power down the server and unplug all peripheral devices and the AC power cable(s).
3.Remove the chassis cover. For instructions, see “Removing the Chassis Cover.”
4.Remove the front bezel if it is installed. For instructions, see “Removing and Installing the Front Bezel.”
5.Disconnect the
6.Disconnect the power cable from the interposer board.
7.Push in on the blue lever at the rear of the drive carrier. Slide the drive carrier out through the front of the chassis.
8.Press downward on the right side of the carrier release the drive from the drive carrier.
9.Remove the two screws at the rear of the
10.Store the screw,
11.Slide the empty drive carrier into the chassis until it clicks into place, or install the slimline filler panel.
12.Install the chassis cover. For instructions, see “Installing the Chassis Cover.”
13.(Optional) Install the front bezel. For instructions, see “Removing and Installing the Front Bezel.”
14.Plug all peripheral devices and the AC power cable(s) back into the server.
Installing and Removing a PCI Riser Card
You can order your choice of one of two PCI riser solutions.
CAUTION
PCI riser connectors are NOT hot swappable. Before removing or replacing the riser connector, you must first take the server out of service, turn off all peripheral devices connected to the system, turn off the system by pressing the power button, and unplug the AC power cord from the system or wall outlet.
Intel® Server Chassis SR1450 User Guide | 43 |