Tascam CC-222MKII owner manual Recording CDs-Basic recording, Frequency conversion

Page 26

5 – Recording CDs—Basic recording

Frequency conversion

The sampling frequency for CDs is 44.1 kHz. The CC-222MKII will always record (and play back) CDs at this frequency.

When recording digital signals, the sampling fre- quency will always be automatically converted to this value, except when recording from a CD, in which case the sampling frequency converter is automati- cally bypassed.

Basic recording

NOTE

According to the “Red Book” (the specification for audio CDs), a track cannot be less than four seconds in length, and there can be a maximum of 99 tracks on an audio CD. Bear these limitations in mind when record- ing.

If you press either the STOP or the PAUSE key within four seconds of starting recording, the unit will con- tinue recording until four seconds have elapsed (since the start of recording) and then stop or pause as appro- priate.

After selecting the input source(s) (, “Input selec- tion”), it is possible to start recording.

The basic record procedure is as follows:

1Load a recordable disc into the unit. As the disc is loaded, the display shows TOC

Reading.

When the disc has been loaded, the display indicators show CD-R, NO TOC, or CD-RW, NO TOC, as appropriate.

2Press the RECORD key. The unit enters record ready mode, as shown by the REC and pause indicators on the display.

3Adjust the level of the source(s), following the guidelines in “Signal volume” on page 25.

NOTE

The red OVER indicators on the meters should never light. Unlike analog equipment, digital audio units pro- duce extremely unpleasant sounds when distorted, and there is no “headroom” after the 0 mark. If recording digitally from a commercially-produced CD, the volume set in the menu should be 0dB. This will maintain all the dynamic range of the source CD without clipping. Only boost the signal if the source is exceptionally quiet.

An analog signal input at nominal level, with no cut or boost from the volume controls, is equivalent to a reading of –16 dB on the meters (on other words, 0 is equivalent to 16 dBFS).

4Press the PLAY key or the PAUSE key to start recording.

Note that there is no need to “cue up” the recording position—the unit always finds the next available location on the disc and start recording to it.

5Press the PAUSE key to pause recording tem- porarily. The pause indicator on the display shows this.

Pressing PAUSE or PLAY again restarts recording with a new track number.

6Press STOP to stop recording. When record- ing stops, the display shows PMA Writing (Program Memory Area) and the REC indicator flashes for a few seconds as the unit writes to the disc.

NOTE

While the “PMA Writing” message is displayed, all keys are disabled, and the unit is actually writing to disc. Do not disconnect the power or subject the unit to severe vibration or shocks at this time, as this will prevent proper recording of the information.

7When this message disappears, you must press the RECORD key (step 2) before restarting the recording. Recording restarts with a new track number.

NOTE

Remember that every time recording is paused or stopped, when recording is restarted, a new track will always be started. It is not possible to record in two “stages” within one track.

26 TASCAM CC-222MKII Owner’s Manual

Page 25 Page 27
Image 26
Page 25 Page 27
Contents CD Recorder/Cassette Deck Important Safety Precautions Important Safety Instructions Safety Information Contents Introduction Some notes and precautionsSupplied accessories Environmental considerations Introduction-Some notes and precautionsRack-mounting the unit Beware of condensationAbout tapes Introduction-FinalizingFinalizing About CD-R and CD-RW discsAdditional notes with regard to CD-R and CD-RW discs Recordable discsHandling of compact discs Recommended media Use of the remote control unitNever use a stabilizer or printable discs Introduction-About this manual About this manualFeatures and controls Monitor TAPE/MIX/DISC switch Features and controls-Rear panel featuresRear panel features Phones jack and volume controlFeatures and controls-Remote control features Remote control featuresNumber keys 0 through 10, +10, Continuous tape/CD playback Cassette operationsPlayback operations Dubbing tapes from the CD deck Cassette operations-Recording operationsRecording operations Dubbing to tape from the middle of a CD Cassette operations-Recording tapes from the Phono deckRecording tapes from the Phono deck Bypassing the Input level for dubbingOther tape functions and features Cassette operations-Other recording featuresOther recording features Search keys Cassette operations-Other tape functions and featuresFast forward and rewind Time display modes CD playerSimple playback operations Track searchProgrammed order playback CD player-Playback modesPlayback modes Repeat play Setting the a and B repeat pointsCD player-Repeat play Intro checkAuto spacing Timer playbackCD player-Auto spacing Input selection Signal volumeRecording CDs Input monitoringFrequency conversion Recording CDs-Basic recordingBasic recording Recording CDs-Dubbing from tape to disc Dubbing from tape to discDubbing to CD from the middle of the tape Recording CDs-From the Riaa Phono inputsFrom the Riaa Phono inputs Advanced recording Setting the trigger levelRecording CDs-Advanced recording Synchronized recordingSync recording start Sync recording stopAutomatic track division Rec mute functionTo perform a fade-out Fade-in and fade-outTo perform a fade-in Unfinalizing CD-RW discs After recordingErasing Erasing tracksRefreshing a disc After recording-ErasingErasing a whole disc After recording-Erasing Reference and specifications TroubleshootingMenu items Reference and specifications-Menu itemsSpecifications CD recorder sectionCassette recorder section Reference and specifications-SpecificationsPhono input and headphones Tape maintenance Reference and specifications-Dimensional drawingDimensional drawing General specificationsCC-222@#
Related manuals
Manual 2 pages 55.43 Kb

CC-222MKII specifications

The Tascam CC-222MKII is a versatile and reliable combination deck that has been designed for professional audio applications. Combining the best of both worlds, this deck features a high-quality CD player and a cassette recorder, making it an ideal solution for musicians, broadcasters, and sound engineers. One of the main features of the CC-222MKII is its ability to play and record CDs as well as standard cassette tapes, which provides users with flexibility in audio formats.

The CD player in the CC-222MKII is compatible with various disc formats, including CD-R and CD-RW, allowing users to play back personalized audio compilations or recordings. Tascam has integrated a high-performance DAC (Digital to Analog Converter) within the unit, which ensures accurate sound reproduction with minimal distortion. Additionally, the player accommodates seamless playback, so users can easily transition between tracks or scan through content, enhancing the overall listening experience.

In terms of cassette functionality, the CC-222MKII offers a built-in cassette deck that utilizes a high-quality transport mechanism. This ensures smooth and reliable tape playback and recording. The deck features both playback and record capabilities for standard compact cassettes, with a user-friendly interface making it easy to navigate controls and manage audio content.

The Tascam CC-222MKII also incorporates several crucial technologies to support its functionality. One notable feature is the built-in A/D (analog to digital) and D/A (digital to analog) converters, which facilitate high-quality recording and playback. Furthermore, the unit includes a range of input options, including XLR and RCA connectors, allowing users to connect external microphones, mixers, or other audio equipment.

Another key characteristic of the CC-222MKII is its ease of use. The deck is equipped with a large LCD display that provides clear information about the current playing track, time elapsed, and other essential data. The intuitive layout and handling make it accessible for both beginners and seasoned professionals.

Moreover, the durable construction of the Tascam CC-222MKII ensures longevity and reliability in various settings, whether in a studio environment or on the road. Its compact design allows for easy integration into any audio setup, making it a popular choice for a wide range of users seeking versatility and performance in an all-in-one audio solution.
Top Page Image Contents