Figure 8. Reinstalling the screw to secure the system stand hinge cover to the computer
Removing and reinstalling the system stand
Attention:
Do not open your computer or attempt any repair before reading and understanding the “Important safety information” on page v.
This section provides instructions on how to remove and reinstall the system stand.
To remove and reinstall the system stand, do the following:
1.Remove any media from the drives and turn off all attached devices and the computer.
2.Disconnect all power cords from electrical outlets.
3.Disconnect the power cords, Input/Output cables, and any other cables that are connected to the computer. See “Locating connectors, controls, and indicators on the front of your computer” on page 8 and “Locating connectors on the rear of your computer” on page 10.
4.Place a soft, clean towel or cloth on the desk or surface. Hold the sides of your computer and gently lay it down so that the screen is against the surface and the cover is facing up.
5.Remove the system stand hinge cover. See “Removing and reinstalling the system stand hinge cover” on page 27.
Chapter 5. Installing or replacing hardware 29