Sanyo VMC-L2619, VMC-L2617 instruction manual Instructions for Use

L8MAP_MAQ_US_XE_JP(GB_FE_ES_DE_CS_JP).book 6 ページ ２００９年７月７日 火曜日 午後４時５７分

Instructions for Use

Power On/Off

1Switch the POWER button on.

•There will be a few seconds delay before the display appears.

•If no signal is being received in VGA mode, the power indicator will flash.

POWER

2When viewing is finished, press the POWER button.

System ID

The System ID can be set for each monitor.

Ensure that the System ID matches the remote controller ID (Remote ID).

1 2 3

1

(Factory default) System ID/Remote ID : 1 2 POWER

1Setting the unit System ID.

Press MENU button on the unit; use the cursor button to select the "System ID" setting from the Setup menu, and then select an ID No. Close the menu screen.

2Setting the Remote ID

While holding down the SYSTEM ID button, set the same number as the System ID number by pressing the corresponding Number button [0-9].

•Press the ID RESET button to return the remote controller ID to the factory default "1".

•Press the SYSTEM ID button to confirm the current System ID and Remote ID.

1	2	3
4	5	6
7	8	9
ID RESET		SYSTEM ID
	0

Basic Operations on the Menu-Screen

To display / exit the main menu

Main Menu

Picture

Mode		: Dynamic		X
Contrast				100
Brightness				45
Sharpness				50
Color				55
Tint	G 50		R 50
Color Tone		: Normal		X
Backlight	: 10			X

TMore

Move Enter Return

A

To return to the previous

ENTER

menu-screen

Button Operation Guide

B

C

B

To select the menu To decide the menu

		Picture
Picture	Mode	: Dynamic			X
	Contrast				100
	Brightness				45
Sound	Sharpness				50
	Color				55
	Tint	G 50		R	50
Setup	Color Tone	: Normal			X
	Backlight	: 10			X
Input	TMore
	Move	Enter	Return

	Picture
Mode	: Dynamic		X
Contrast			100
Brightness			45
Sharpness			50
Color			55
Tint	G 50	R	50
Color Tone	: Normal		X
Backlight	: 10		X
TMore
Move	Enter	Return

■How to Configure Setting Using Adjustment Bar

Note:

The OSD display will be disapear after 2 minutes if there is no button input.

ENTER		ENTER
S
Contrast		100
T
Move	Adjust	Return

ENTER

Button Operation Guide

English 6