Installation
Attaching the Cable Cover
It is recommended to attach the cable covers to protect the terminal area from dust when hanging the projector from the ceiling. Please connect the covers to the projector with the provided straps to prevent the covers from falling off.
Follow these steps to attach the support cover and cable cover.
1 | Tie a strap (supplied) to the lower bracket on the right side |
| of the projector’s terminal area. (See the right figure.) |
2 | Fix the opposite end of the strap to the hole inside the |
| support cover with a screw (supplied). |
3 | Insert the support cover into the cover insertion slot and |
| slide it to the left. |
4 | Dress and secure all cables to a cable tie (supplied). The |
| cable tie is reusable and can be opened and closed as |
| many times as needed. |
5 | Tie another strap (supplied) to the upper bracket on the |
| right side of the projector’s terminal area. |
6 | Fix the opposite end of the strap to the hole inside the |
| cover with a screw (supplied). |
7 | To attach the cover, insert the rods inside the cover into |
| the holes on the side cover until it clicks. (See the right |
figure.)
✔Note:
•Attach the support cover first, otherwise the cover cannot be fixed properly.
Cover | Strap |
insertion slot |
Screw
Support
Cover
Cable tie
Strap
Screw
Cover
22