Hitachi 8880R manual Returning the Settings to Defaults, Returning the ICU Settings to Defaults

Ch 2: System Environment Setting

Returning the Settings to Defaults

This section explains how to return the settings to defaults and what action to take when you cannot start the utility. Read this section as required.

Returning the Settings of the Setup Information to Defaults

Referring to “Load Setup Defaults” in “What You Can Do on the Exit Menu” on page 35, return the settings of the Setup information to defaults. After that, be sure to change the settings against “List of Utility Settings” on page 50.

Returning the ICU Settings to Defaults

1.“Restoring Configuration Information” on page 47, return the settings top defaults.

2.“List of Utility Settings” below, change the settings to Hitachi VisionBase 8880R Server settings.

List of Utility Settings

ICU (ISA Configuration Utility)

This table defines the ICU factory default settings.

Item	Default Setting Value
Motherboard System Device
ISA Bridge	Fixed Configuration
System Peripheral	Fixed Configuration
RAM Controller	Fixed Configuration
DMA Controller	Fixed Configuration
Interrupt Controller	Fixed Configuration
System Timer Controller	Fixed Configuration
Real Time Clock Controller	Fixed Configuration
Keyboard Controller	Fixed Configuration
CPU	Fixed Configuration
Multi-Media Audio Controller	Fixed Configuration
PCI Bridge	Fixed Configuration
Serial port	Choice 1
IRQ	4
DMA	None
Memory [Hex]	None
I/O port [Hex]	3f8–3ff
Floppy Controller	Choice 1
IRQ	6
DMA	2
Memory [Hex]	None
I/O port [Hex]	3f0–3f5
	3f7

50 Hitachi VisionBase 8880R Server