Hitachi CP-S830W/E specifications Installation, Example of the projector and screen installation

Page 11

Installation

Example of the projector and screen installation

Determine picture size and projection distance as illustrated below.

View from the top

View from the side

Screen

Lens center

a

ENGLISH

	Screen (inch)	a (inch)

		Minimum	Maximum
		Minimum	Maximum

	40	67	87

	60	98	130

	80	130	173

	100	165	217

	120	197	260

	150	248	327

	200	331
	200	331

a:Distance from the projector to the screen. (tolerance : 10%)

This screen size is full-screen size.(800 dots X 600 dots)

Installation of liquid crystal projector

Please basically use liquid crystal projector at the horizontal position.

If you use liquid crystal projector by the lens up position, the lens down position and the side up position, this may cause the heat inside to build up and become the cause of damage.

Be especially careful not to install it with ventilation holes blocked.

How to use foot adjusters

Adjust the projection position using the foot adjusters at the bottom of the projector.

View from the front

View from the side

Foot adjuster

A viewing angle of 0û~9û can be changed.

1.Lift up the projector and press the button of the adjuster to release the lock.

2.Adjust the projection angle, release the button of the adjuster and securely lock it.

3.To adjust the angle slightly, revolve the foot adjusters.

Caution

∙Do not unlock the foot adjusters while you do not support the projector, to avoid falling of the projector and causing an injury.

∙Do not revolve the foot adjusters by force, the foot adjusters is damaged.

∙Securely lock the adjuster.

∙Do not apply unnecessary force from the upper side when lifting the projector. Otherwise, projector may be damaged or a finger could be caught and cause injury.

11

Image 11

Contents Operating Guide FeaturesContents OutlineFor the Customers in U.K Instructions to Users Video signal cablesPower cord Before useIf any abnormality occurs Do not look directly at the lens when Lamp is litDo not install this unit in an unstable place Do not use power supplies other Than that specifiedDo not step on this unit or do not put a Heavy object on it Be careful in handling the power cordCleaning Handle the power cord carefullyVolume When you are not going to use For a long timeClean inside the unit at least once two years Do not place this unit where it gets hotMain unit Names and functions of each partVideo input terminal AC in socket Main Power switchRemote control sensor RGB input terminal RGB output terminalRemote control transmitter Replace the cover How to insert batteriesView from the top InstallationExample of the projector and screen installation How to use foot adjustersTo project the picture Basic operationsPLUG&PLAY To turn off the powerMemory function Adjustments and functionsTo return to the initial setting Adjustment Item Details of adjustment SET UPImage InputMenu OPT. allows you to control communication function etc OPTConnection to the RGB signal terminal Connection to the video signal terminalsKHz Type Example of computer signalResolution Standard Display Dots Computer/signal Horizontal Timing µs Initial set signalsControl signal terminal Connection to the control signal terminalSerial mouse PS/2 mouseADB Mac mouse Communication Control command tableControl command table Control data table Example of command error Procedure of getting the Projector statusProcedure of setting the Projector status Procedure of default setting the Projector statusConnecting various equipment Example of system setupClean the air filter using a vacuum cleaner Cleaning the air filterLoosen two screws and pull Handle to remove Lamp.Screw How to replace lampRemove the lamp cover On-screen display Reset the lamp timeLamp Message tableWhen you think something wrong Specifications