Hitachi CP-S830W/E specifications How to insert batteries, Replace the cover

Page 10

Names and functions of each part (continued)

How to insert batteries

Insert the provided batteries (AA or R6P) into the remote control transmitter.

1

Remove the battery compartment cover.

2

Insert the batteries as illustrated inside

the battery compartment.

Slide the battery compartment cover in the direction of the arrow while pressing slightly down on it.

Caution Cautions on use of batteries

∙Do not use batteries not specified for this unit. Also do not use old and new batteries together. It may cause a fire, injury due to burst of battery or liquid leakage.

∙When inserting batteries, pay attention to the direction of the and polarity indications and insert the batteries correctly. If the polarities are confused, it may cause injury or damage near the unit due to a burst of battery

3Replace the cover.

Caution Cautions on use

∙Do not drop the remote control transmitter or apply any shock to it.

∙Do not let the remote control transmitter get wet and do not put it on a wet object. It may cause a malfunction.

∙If you are not going to use it for a long time, remove the batteries from the remote control transmitter.

∙If operation of the remote control becomes difficult, replace the batteries.

10

Image 10

Contents Outline FeaturesContents Operating GuideFor the Customers in U.K Before use Video signal cablesPower cord Instructions to UsersDo not use power supplies other Than that specified Do not look directly at the lens when Lamp is litDo not install this unit in an unstable place If any abnormality occursHandle the power cord carefully Be careful in handling the power cordCleaning Do not step on this unit or do not put a Heavy object on itDo not place this unit where it gets hot When you are not going to use For a long timeClean inside the unit at least once two years VolumeNames and functions of each part Main unitRGB output terminal AC in socket Main Power switchRemote control sensor RGB input terminal Video input terminalRemote control transmitter How to insert batteries Replace the coverHow to use foot adjusters InstallationExample of the projector and screen installation View from the topBasic operations To project the pictureTo turn off the power PLUG&PLAYTo return to the initial setting Adjustments and functionsMemory function SET UP Adjustment Item Details of adjustmentInput ImageOPT Menu OPT. allows you to control communication function etcConnection to the video signal terminals Connection to the RGB signal terminalResolution Standard Display Dots Example of computer signalKHz Type Initial set signals Computer/signal Horizontal Timing µsConnection to the control signal terminal Control signal terminalADB Mac mouse PS/2 mouseSerial mouse Control command table Control command tableCommunication Control data table Procedure of default setting the Projector status Procedure of getting the Projector statusProcedure of setting the Projector status Example of command errorExample of system setup Connecting various equipmentCleaning the air filter Clean the air filter using a vacuum cleanerRemove the lamp cover How to replace lampLoosen two screws and pull Handle to remove Lamp.Screw Message table Reset the lamp timeLamp On-screen displayWhen you think something wrong Specifications