Hitachi CP-S830W/E Connection to the control signal terminal, Control signal terminal

Page 21

Connection to the control signal terminal

1. Control signal terminal

	Pin No.	RS-232C		Mouse
	Pin No.	RS-232C	PS/2	ADB	Serial
			PS/2	ADB	Serial

	1				TDM

	2		CLK	SDATA

	3		DATA

	4

	5

	6		SEL0		SEL0

	7			SEL1	SEL1

	8				READY

	9

	10	GND	GND	GND	GND

	11

	12		+5V	+5V

13RDP

14TDP

15

610

11 15

D-sub 15pin shrink terminal (Male)

ENGLISH

	Caution	Turn off the power of both the projector and computer before connecting.
	Caution	Connect the computer to the control terminal of the projector using an appropriate cable.

		Refer to the instruction manual of each device before connecting.

2.Mouse emulation

(1)Connect the projector and the mouse terminal of computer using an appropriate cable, while the projector and the computer are turn off.

(2)Turn the power of the projector on and press the STANDBY/ON switch. The indicator will light. (The ON indicator will light up orange.).

(3)Press the INPUT of the projector or RGB 1/2 button of the remote control transmitter and select the input connection.

(4)Turn on the computer.

(5)Start mouse emulation mode.

If can not start mouse emulation, reset the computer. (With soft reset or reset switch)

(6)See on the page 9 about to operate the remote control transmitter.

Caution : Mouse cannot be operated while start up screen or menu screen is being displayed.

	Caution	∙ In some note computers which have internal pointing device, mouse emulation don't work
	Caution	without setting the internal pointing device disabled. In this case, set the internal pointing

		device disabled in BIOS setting. After setting in BIOS, operate (1) ~ (5) Please check its
		hardware manuals to disable internal pointing device in BIOS setting.

∙In some computers, mouse emulation don't work without the utility program. In this case, see and check the operating manuals of the computer.

21

Image 21

Contents Contents FeaturesOutline Operating GuideFor the Customers in U.K Power cord Video signal cablesBefore use Instructions to UsersDo not install this unit in an unstable place Do not look directly at the lens when Lamp is litDo not use power supplies other Than that specified If any abnormality occursCleaning Be careful in handling the power cordHandle the power cord carefully Do not step on this unit or do not put a Heavy object on itClean inside the unit at least once two years When you are not going to use For a long timeDo not place this unit where it gets hot VolumeMain unit Names and functions of each partRemote control sensor RGB input terminal AC in socket Main Power switchRGB output terminal Video input terminalRemote control transmitter Replace the cover How to insert batteriesExample of the projector and screen installation InstallationHow to use foot adjusters View from the topTo project the picture Basic operationsPLUG&PLAY To turn off the powerAdjustments and functions To return to the initial settingMemory function Adjustment Item Details of adjustment SET UPImage InputMenu OPT. allows you to control communication function etc OPTConnection to the RGB signal terminal Connection to the video signal terminalsExample of computer signal Resolution Standard Display DotsKHz Type Computer/signal Horizontal Timing µs Initial set signalsControl signal terminal Connection to the control signal terminalPS/2 mouse ADB Mac mouseSerial mouse Control command table Control command tableCommunication Control data table Procedure of setting the Projector status Procedure of getting the Projector statusProcedure of default setting the Projector status Example of command errorConnecting various equipment Example of system setupClean the air filter using a vacuum cleaner Cleaning the air filterHow to replace lamp Remove the lamp coverLoosen two screws and pull Handle to remove Lamp.Screw Lamp Reset the lamp timeMessage table On-screen displayWhen you think something wrong Specifications