Hitachi HOME-1 Turning Off The Power, Switch the power switch to O OFF, Attached the lens cap

Page 16

Power ON/OFF (continued)

Turning Off The Power

NOTE • Turn the power on/off in right order. Please power on the projector before the connected devices. Power off the projector after the connected devices.

1 Press the STANDBY/ON button of the projector or the OFF button of the remote control.

The message “Power off?” will appear on the screen for approximately 5 seconds.

2 Press the STANDBY/ON button or the OFF button again while “Power off?” the message is visible.

The projector lamp will go off, and the POWER indicator will begin blinking orange.

Then the POWER indicator will stop blinking and light to solid orange when the lamp cooling is complete.

3	Switch the power switch to [O] (OFF).
	Power switch (OFF position)
	The POWER indicator will go off.
4	Attached the lens cap.

POWER indicator

TEMP

POWERLAMP

STANDBY/ON INPUT

STANDBY/ON button

Power switch

OFF button

SEARCHOFF

SRC

VIDEO S-VIDEO COMPONENT

V SV C

COMPUTERVOLUME

Image 16

Contents HOME-1 ProjectorProjector Features PreparationContents Projector Part NamesFastening The Lens Cap Projector ON/OFFRemote Control To adjust the keystoneTo adjust the volume Component VideoSetting Up ArrangementAdjusting The Projectors Elevator Using The Picture Shift DialsAdjust the height of the projector by As necessary, you can also finelyConnecting Your Devices Connecting to a computer AUDIO-L AUDIO-R G B RConnecting Power Supply Remote Control Remove Battery coverClose Battery cover Putting BatteriesOperating The Remote Control Power ON/OFF Turning On The PowerWhen the lens cap is attached, remove Set the power switch to onSelecting An Input Signal Using the projector’s control buttonUsing the remote control Press the COMPUTER, VIDEO, S-VIDEO Press the Input buttonTurning Off The Power Switch the power switch to O OFFPower switch OFF position Attached the lens capOperating Adjusting The VolumeTemporarily Muting The Sound Using The Automatic Adjustment Feature Correcting Keystone DistortionsSelecting The Aspect Ratio Signal SearchingTemporarily Blanking The Screen Selecting The Gamma Mode Recalling Your AdjustmentsMultifunctional Settings Using The Menu FunctionsMain Menu Picture 1 Menu Load/Save a Setting Reset the PICTURE-1 Menu ItemsPicture 1 Menu MY MemoryPhase Picture 2 MenuPosition SizeInput Menu VideoFrame Lock 3D-YCSInput Menu Video NRInformation S2-ASPECTAuto Menu AdjustSearch Start UP Screen MenuMessage Option Menu VolumeLamp Time Lamp Replacing The Lamp Air Filter Caring For The Air FilterReplacing The Air Filter New air filter. Tell the dealer your airHold the release buttons of the air Filter, while pulling down itCaring For The Cabinet And Remote Control Other CareCaring For The Inside Of The Projector Caring For The LensTroubleshooting Related MessagesRelated Messages Regarding The Indicator Lamps Power Lamp TempRegarding The Indicator Lamps IndicatorPhenomena That May Easily Be Mistaken For Machine Defects Warranty And After-Service Phenomena That May Easily Be Mistaken For Machine DefectsSpecifications SpecificationRGB Input Ports Audio Ports Video Input PortsSignal Connectors TechnicalResolution FH kHz FV Hz Rating Signal mode Example Of Computer SignalText Initial Set Signals Communications Setting Connecting The CableRS-232C Communication Requesting projector status Get command Changing the projector settings Set commandUsing the projector default settings Reset Command Increasing the projector setting value Increment commandCommand Data Chart 4A D2日本語 Be EF EF F6 Be EF EC D9 Auto RGB Be EF CB D3 Turn on Be EF

Power ON/OFF (continued)

Turning Off The Power

Switch the power switch to [O] (OFF).

Power switch (OFF position)

Attached the lens cap.