Hitachi HOME-1 Signal Searching, Selecting The Aspect Ratio, Temporarily Blanking The Screen

Operating (continued)

Signal Searching

ON

SEARCHOFF

SRC

VIDEO S-VIDEO COMPONENT

V SV C

COMPUTERVOLUME

PC

AUTO WIDE BLANK MUTE

AT WID

CINEMA DYNAMIC NORMAL CUSTOM

1	Press the SEARCH button.
	Cycle through input signals, displaying the images of retrieved signals. If
	no signal is found, returns to the signal that was selected before the search
	was begun.
	COMPUTER	VIDEO	S-VIDEO
			SEARCH
	COMPONENT VIDEO

NOTE • May not function properly with some input signals.

•The signal searching function takes about 10 seconds to display an image.

Selecting The Aspect Ratio

ON

SEARCHOFF

SRC

VIDEO S-VIDEO COMPONENT

V SV C

COMPUTERVOLUME

PC

AUTO WIDE BLANK MUTE

AT WID

CINEMA DYNAMIC NORMAL CUSTOM

CIN DYN NOR CUS

MYMEMORY

M1 M2 M3 M4

KEYSTONEMENU

ENTER

ENT

ESC RESET

E

1 Press the WIDE button.
COMPUTER input			WIDE
4:3	16:9	15:9	32:15

•At a COMPUTER input, selecting an aspect ratio may display the message “SYNC IS OUT OF RANGE”. In this case, please select one of other aspect ratios.

VIDEO, S-VIDEO, COMPONENT VIDEO input

4:3 16:9 WIDE MOVIE-1 MOVIE-2

•At a COMPONENT VIDEO input of 16:9 Hi-Vision of 1125i (1035i/1080i)/750p, only 16:9 can be selected.

Temporarily Blanking The Screen

PC				1	Press the BLANK button.
AUTO	WIDE	BLANK	MUTE		The input signal screen is shut off, and a blank screen appears. You can
AT	WID				set the blank screen using the menu (from the SCREEN menu, BLANK
CINEMA	DYNAMIC NORMAL CUSTOM
CIN	DYN	NOR	CUS		select BLANK).
	MYMEMORY				Press the BLANK button again to remove the blank screen,
M1	M2	M3	M4
					and return to the input signal screen.
KEYSTONE			MENU
NOTE		• The temporarily blanking function will automatically finish if a button of the remote control

except the , , , , ENTER, ESC, RESET or ON button is pressed, or if a button of projector is pressed, or if there is a change in the input signal’s state.

19