Kodak I3400, I3200 manual Cleaning the feed module tires, Cleaning the imaging, Guides

Cleaning the feed module tires

9.Clean the feed module tires by manually rotating and wiping the feed module tires with a roller cleaning pad. For best results wipe parallel to the ribs in order to remove any residue between the ribs. You do not need to remove the feed module to clean the tires.

10.Inspect the tires. If the tires show signs of wear or damage, replace the feed module tires or the feed module. See “Replacement procedures” later in this chapter.

Cleaning the background 11. Wipe the upper and lower background strips with a Staticide wipe. strip(s)

	12.	Wipe the upper and lower background strips again with an almost-dry
		Staticide wipe to remove any streaks.
Cleaning the imaging	13.	Wipe the upper and lower imaging guides with a Staticide wipe.
guides

14.Wipe the upper and lower imaging guides again with an almost-dry Staticide wipe to remove any streaks.

15.Close the scanner cover.

16.When finished with all cleaning procedures, turn on the scanner.

A-61771 September 2012 5-5