FARGO electronic
Quatro ID Card Printer
manual
Troubleshooting
Specifications
Maintenance
Release Tab Printhead Assembly
IX. Cleaning the Drive Roller
Powering Up the Printer
Dither Mode
Page 56
Printed in the United States of America P/N 510323
Page 55
Page 56
Image 56
Page 55
Page 56
Contents
Quatro ID Card Printer UserÕs Manual
Printing History
Table of Contents
Appendix a Magnetic Stripe Encoding Module
Getting Started
Thank YOU
Choosing a Good Location
II. about Moisture Condensation
III. Unpacking and Inspection
Powering Up the Printer
Applying Power
Power Input Port
II. Identifying the Printer Features
Ribbons and Cards
About Ribbons
II. Loading Ribbon Into the Printer
Release Tab Printhead Assembly
Take-up Ribbon Supply Ribbon Drive Hubs Ribbon Sensor
III. about Cards
IV. Loading Cards Into the Printer
Card Stack Card Input Tray
Printing a Self Test
Using the Quatro ID Card Printer
Connecting the Printer to Your Computer
II. Installing the Windows Printer Driver
Windows 95/98 or Windows NT
Windows
III. Installing the 32-BIT Print Spooler for Windows 95/98
Panel
Using the Quatro ID Card Printer
IV. Setting UP the Windows Printer Driver
Card Size
Windows 95/98
Windows NT
Color Matching
Controls
Dither Mode
Fast 32-bit Spooler
Panel Graphics
No Margins
Mag Encode Only
Magnetics
Position
Rear of Printer
Write Direct to Port
Ribbon Type
Rotate
Printing a Card
Maintenance
Supplies Required
II. Standard Printhead Cleaning
III. Expanded Printhead Cleaning
IV. Cleaning the PRINTER’S Case
Cleaning the Inside of the Printer
VI. Clearing a Card JAM
VIII. Cleaning the Card Feed Rollers
VII. Clearing a Ribbon JAM
Insert this end first Sticky Side Up
IX. Cleaning the Drive Roller
Maintaining the Cleaning Rollers
Maintenance
On-line LED light is flashing
Troubleshooting
Printer doesn’t work at all
On/cancel LED light is flashing
’m having problems printing from Windows 95/98
Ribbon doesn’t seem to wind or print properly
Card or ribbon is jammed
Ribbon has torn or even broken
My prints have streaks in them
My prints have blotches small voids in them
Photos on my ID cards look very pixelated
Card won’t feed and the on-line LED starts blinking
Printing gets cut off or is not centered on the card
Two or more cards feed at the same time
Technical Specifications
Printing Area
Encoding Mode / Magnetic Track Selection
Magnectic Track Options
Magnetic Track Options
Encoded Bit Density
LRC Generation Mode
Character Data Size
Character Ascii Offset
Character Data Parity
II. Track Locations
III. Sending Track Information
~1%JULIE ANDERSON623-85-1253?
II. CENTRONICS-TYPE Parallel Interface
Appendix B Interfacing Information
Introduction
Index
Drive roller
Ribbon type
Page
Top
Page
Image
Contents