FARGO electronic Quatro ID Card Printer manual Powering Up the Printer, Applying Power

Page 7

Chapter 2: Powering Up the Printer

I. APPLYING POWER

1.Locate the ÒDesk-Top TransformerÓ supplied with your system. Check that it is properly configured for the power used in your country.

-TOP DESK TRANSFORMER

CAUTION!

!

IF YOU HAVE ANY DOUBTS ABOUT THE PLUG CONFIGURATION OR THE VOLTAGE, DO NOT ATTEMPT TO USE THE PRINTER. CONTACT YOUR AUTHORIZED QUATRO RESELLER FOR INFORMATION ON THE CORRECT TRANSFORMER. USE YOUR PRINTER ONLY IF YOU ARE CERTAIN THAT THE PLUG AND POWER RATING ARE CORRECT.

THE QUATRO TRANSFORMER IS DESIGNED FOR DESKTOP USE ONLY.

Powering Up the Printer 3

Image 7

Contents Quatro ID Card Printer UserÕs Manual Printing History Table of Contents Appendix a Magnetic Stripe Encoding Module II. about Moisture Condensation Getting StartedThank YOU Choosing a Good LocationIII. Unpacking and Inspection Applying Power Powering Up the PrinterPower Input Port II. Identifying the Printer Features About Ribbons Ribbons and CardsII. Loading Ribbon Into the Printer Release Tab Printhead Assembly Take-up Ribbon Supply Ribbon Drive Hubs Ribbon Sensor IV. Loading Cards Into the Printer III. about CardsCard Stack Card Input Tray Printing a Self Test Connecting the Printer to Your Computer Using the Quatro ID Card PrinterWindows 95/98 or Windows NT II. Installing the Windows Printer DriverWindows Panel III. Installing the 32-BIT Print Spooler for Windows 95/98Using the Quatro ID Card Printer IV. Setting UP the Windows Printer Driver Windows NT Windows 95/98Card Size Controls Color MatchingFast 32-bit Spooler Dither ModePanel Graphics Magnetics Mag Encode OnlyNo Margins Rear of Printer PositionRotate Ribbon TypeWrite Direct to Port Printing a Card Supplies Required MaintenanceII. Standard Printhead Cleaning IV. Cleaning the PRINTER’S Case III. Expanded Printhead CleaningVI. Clearing a Card JAM Cleaning the Inside of the PrinterVII. Clearing a Ribbon JAM VIII. Cleaning the Card Feed RollersInsert this end first Sticky Side Up Maintaining the Cleaning Rollers IX. Cleaning the Drive RollerMaintenance Printer doesn’t work at all TroubleshootingOn-line LED light is flashing ’m having problems printing from Windows 95/98 On/cancel LED light is flashingRibbon doesn’t seem to wind or print properly Ribbon has torn or even broken Card or ribbon is jammedMy prints have blotches small voids in them My prints have streaks in themTwo or more cards feed at the same time Photos on my ID cards look very pixelatedCard won’t feed and the on-line LED starts blinking Printing gets cut off or is not centered on the cardPrinting Area Technical SpecificationsMagnectic Track Options Encoding Mode / Magnetic Track SelectionEncoded Bit Density Magnetic Track OptionsCharacter Data Parity LRC Generation ModeCharacter Data Size Character Ascii OffsetIII. Sending Track Information II. Track Locations~1%JULIE ANDERSON623-85-1253? Introduction Appendix B Interfacing InformationII. CENTRONICS-TYPE Parallel Interface Drive roller IndexRibbon type Page