FARGO electronic Quatro ID Card Printer manual Maintenance

Page 38

5.Reach down and grasp the end of the Cleaning Roller Assembly which is closest to the front of the printer. Lift this end first, and gently maneuver the assembly out of the printer.

6.Once the Cleaning Roller Assembly is removed, clean the rollers using one of the adhesive-backed Cleaning Cards from the Printer Cleaning Kit. With the cardÕs adhesive backing paper removed, slide the card between the rollers until all dust particles are removed. If you do not have a Cleaning Card, use a piece of standard clear adhesive tape. Use the sticky side of the tape to lift dust from the rollers.

7.Once all debris is removed from the rollers, place the roller assembly back into the printer, replace the ribbon, and close the printerÕs Printhead Assembly and Top Cover.

34 Maintenance

Image 38

Contents Quatro ID Card Printer UserÕs Manual Printing History Table of Contents Appendix a Magnetic Stripe Encoding Module Choosing a Good Location Getting StartedThank YOU II. about Moisture CondensationIII. Unpacking and Inspection Powering Up the Printer Applying PowerPower Input Port II. Identifying the Printer Features Ribbons and Cards About RibbonsII. Loading Ribbon Into the Printer Release Tab Printhead Assembly Take-up Ribbon Supply Ribbon Drive Hubs Ribbon Sensor III. about Cards IV. Loading Cards Into the PrinterCard Stack Card Input Tray Printing a Self Test Using the Quatro ID Card Printer Connecting the Printer to Your ComputerII. Installing the Windows Printer Driver Windows 95/98 or Windows NTWindows III. Installing the 32-BIT Print Spooler for Windows 95/98 PanelUsing the Quatro ID Card Printer IV. Setting UP the Windows Printer Driver Card Size Windows 95/98Windows NT Color Matching ControlsDither Mode Fast 32-bit SpoolerPanel Graphics No Margins Mag Encode OnlyMagnetics Position Rear of PrinterWrite Direct to Port Ribbon TypeRotate Printing a Card Maintenance Supplies RequiredII. Standard Printhead Cleaning III. Expanded Printhead Cleaning IV. Cleaning the PRINTER’S CaseCleaning the Inside of the Printer VI. Clearing a Card JAM VIII. Cleaning the Card Feed Rollers VII. Clearing a Ribbon JAMInsert this end first Sticky Side Up IX. Cleaning the Drive Roller Maintaining the Cleaning RollersMaintenance On-line LED light is flashing TroubleshootingPrinter doesn’t work at all On/cancel LED light is flashing ’m having problems printing from Windows 95/98Ribbon doesn’t seem to wind or print properly Card or ribbon is jammed Ribbon has torn or even brokenMy prints have streaks in them My prints have blotches small voids in themPrinting gets cut off or is not centered on the card Photos on my ID cards look very pixelatedCard won’t feed and the on-line LED starts blinking Two or more cards feed at the same timeTechnical Specifications Printing AreaEncoding Mode / Magnetic Track Selection Magnectic Track OptionsMagnetic Track Options Encoded Bit DensityCharacter Ascii Offset LRC Generation ModeCharacter Data Size Character Data ParityII. Track Locations III. Sending Track Information~1%JULIE ANDERSON623-85-1253? II. CENTRONICS-TYPE Parallel Interface Appendix B Interfacing InformationIntroduction Index Drive rollerRibbon type Page