|
| COMMAND CENTER Pages | |
|
|
|
|
|
|
|
|
| Item | Description | |
|
|
|
|
| IP Address | Assigns an IPv6 address to the printing system network | |
|
| component. | |
|
| The format of the IPv6 address is a sequence of numbers | |
|
| (128 bit in total) separated by colons, e.g. | |
|
| 2001:db8:3c4d:15::1a2c:1a1f. | |
|
|
|
|
| Prefix | Specifies the IPv6 prefix length. It can be a decimal value | |
| Length | between 1 and 128. | |
|
|
|
|
| RA | Select On to use RA instead of the DHCP server to | |
| (Stateless) | configure IPv6 addresses. | |
|
|
|
|
| Default | Specifies the IPv6 address of the default gateway. | |
| Gateway |
|
|
DHCPv6
(Stateful)
Specifies whether or not to obtain IPv6 IP addresses by automatic configuration. When RA is turned On, the IP addresses and server information are obtained via DHCPv6 based on the settings of the automatic configuration made under RA (router setting).
Domain | Specifies the DNS (Domain Name System) name of the |
Name | domain to which the printing system belongs. |
|
|
DNS | Specifies the IP addresses of the primary and secondary |
Servers | DNS (Domain Name System) servers. When DHCPv6 |
(Primary, | (Stateful) is turned On, you can select to use either the DNS |
Secondary) | servers obtained via DHCP or the DNS servers being set |
| under this item. |
|
|
Advanced > Protocols > TCP/IP > IP Filters
This page allows you to configure IP filters. IP filters restrict access to the printing system based on the IP addresses and protocols.
Specify the IP addresses or network addresses of the hosts to which access is granted.
If nothing is specified on this page, access from all hosts is allowed.
Item | Description |
|
|
IP Filter (IPv4) | Specifies the IP address or network address to be permitted. |
IP Address | The number of specifiable entries differs depending on |
(IPv4) | models. |
|
|
Subnet | Specifies the subnet mask to be permitted. |
Mask | To permit access from all hosts on network 192, enter |
| "192.0.0.0" for the IP address and "255.0.0.0" for the subnet |
| mask. |
| Subnet mask can be left blank. |
|
|
Operation Guide | 35 |