
COMMAND CENTER Pages
Item | Description | |
|
| |
Protocols | Specifies the protocol to be permitted. The following | |
| protocols can be selected. | |
| - | LPD |
| - | FTP |
| - | IPP |
| - | HTTP |
| - | SNMP |
| - | RAW Port |
| - | IPP over SSL |
| - | HTTPS |
|
| |
IP Filters (IPv6) | Specifies the IP addresses to which access is granted. The | |
IP Address | number of addresses that can be specified varies depending | |
(IPv6) | on the model used. | |
|
| |
Prefix | Specifies the IPv6 prefix length. It can be a decimal value | |
Length | between 1 and 128. | |
|
| |
Protocols | Specifies the protocols through which access is granted.The | |
| following protocols can be selected. | |
| - | LPD |
| - | FTP |
| - | IPP |
| - | HTTP |
| - | RAW Port |
| - | SNMP |
|
|
|
Advanced > Protocols > TCP/IP > Logical Printers
This page allows you to configure the Logical Printers. This machine can be used as a virtual printer for converting ASCII print data to PostScript data or for adding and/or replacing a character strings (commands) at the beginning or end of job data. Up to four logical printers can be set.
Each logical printer can be used with either the FTP, LPR, IPP, NetBEUI, or Raw Port protocol. All printout to a
Item | Description |
|
|
TCP/IP Port | Specifies the port number for the logical printer as well as |
Number | the TCP raw port number (9100, etc.). Conversion is applied |
| to data that is input to the specified raw port in accordance |
| with the selected logical printer. This port is invalid if it is |
| given a port number that is the same as that of an already |
| specified port (e.g. FTP or LPD). |
Bi-directional Printing
On or Off
In order to have the data that is received from the printer returned to the client when printing with PostScript, PJL and other such commands, it is necessary to On
36 | KYOCERA COMMAND CENTER |