Lexmark 510 setup guide Position the optional drawer

Page 16

Remove any packing material and tape from the tray.

4 Move the support unit to the location selected for the printer.

5 Tip the tray slightly and push it fully into the support unit.

Pull the tray out of the support unit.

3

Remove all packing material and tape from the support unit.

1

2

Step 3: Position the optional drawer

CAUTION: If you are adding an optional drawer sometime after setting up the printer, be sure to turn the printer off, unplug the power cord, and disconnect all cables from the back of the printer before completing these tasks.

Your printer supports an optional

530-sheet drawer. The optional drawer consists of a support unit and a tray.

Unpack the box. Enclosed are:

•a support unit with the tray inside

•two side covers (left and right)

•two metal brackets (left and right) with thumbscrews

Note: When you add or remove the optional drawer, remember to update the printer configuration through your printer driver.

Position the optional drawer

11

Image 16

Contents C510 Edition December Contents Load paper Using the publications CD Introduction About the printerBase Model and Options IntroductionOther sources of information Publications CD Information pagesQuick Reference sheet Drivers CD Lexmark Web site Unpack the printer Getting ready for setupUnpack the printer Setup Guide with a publications CD and Quick Reference sheet Installing toner cartridges Install printer suppliesInstall printer supplies Install printer supplies Close the front door Installing the photodeveloper cartridge Install printer supplies Position the optional drawer Position the optional drawerPositioning the printer Prepare the printerPrepare the printer Securing the drawer to the printer Tighten thumbscrew Bracket Attaching an operator panel overlay Adjusting tray 2 margins Set up the optional duplex unit Set up the optional Duplex unitAttaching the optional duplex unit Redrive Set up the optional duplex unit Set up the optional duplex unit Adjusting duplex margins Install memory, firmware, or option cards Install memory, firmware, or option cardsRemoving the system board Installing printer memory Installing an optional flash memory or firmware card Cards Reinstalling the system board Load paper Load paperLoading the trays Load paper Load paper Attaching a local cable Attach cablesAttach cables Parallel Attaching a network cable EthernetTurning your printer on What do I do next?Install drivers for local printing Install drivers for local printingWindows \drivers\win2000\Select Search for a suitable driver, and then click Next Using Windows 98 with USB or parallel cable Page Macintosh Macintosh 8.6-9.0 Open Apple LaserWriterUNIX/Linux Install drivers for local printing Printing a menu settings Verify printer setupVerify printer setup Printing Quick Reference information Printing a network setupClick Quick Reference Verify printer setup Configure for TCP/IP Configure for TCP/IPAssigning a printer IP address IP settings Configuring for Pull PrintingVerifying RunInstall drivers for network printing Install drivers for network printingSupported printer drivers Supported network printer portsClick Install Printer and Software Printing configuration Operating system Go toSharing Settings PrintersShared Name text box Install the printer driver or subset on network clients Using the point and print methodClick Start Settings Printers Using the peer-to-peer methodClick Network Print Server Choose Printing Change Setup Mac OSClick Applications Utilities Print Center Click Add Printer Click Mac OS X EnglishClick Applications TextEdit NetWare Using the publications Viewing the CD contentsUsing the publications CD Statement of Limited Warranty WarrantyWarranty service Lexmark International, Inc., Lexington, KYLimitation of liability Extent of warrantyAdditional rights 20K1030 K0125