Emerson UPS Systems installation manual Cabinet-to-Cabinet

Page 29

Installation Drawings

Figure 18 Ground strap location for connected cabinets

Reference of corner post of connected cabinets

FRONT SIDE OF

UNITS

A

DETAIL A

	Typical Ground Strap Installation	Cabinet-to-Cabinet
	Typical Ground Strap Installation	Bolting Instructions
	(Use for all connected units except Battery Cabinet)	Bolting Instructions

25

Image 29

Contents Liebert NXL Maintenance Bypass Cabinet Product Warranty Registration Table of Contents Figures Important Safety Instructions Introduction Positioning Power Cables Power Cable Connection Procedure Single-Module Mechanical Installation Installation Drawings Two-Breaker Maintenance Bypass Cabinet, two-input, attached Busbar Detail B Front Section A-A Bottom View Footprint Bottom View Footprint TOP View BUS BAR Detail a BUS Termination Detail Cable routing Front Run From Conductor Bypass Installation Drawings P1 D T Installation Drawings Interlock Control wiring connections withoutFrom Purpose Control wiring connections with interlockSection A-A Cabinet-to-Cabinet Liebert NXL Maintenance Bypass Cabinet specifications SpecificationsRecommended conduit and cable sizes-Maintenance Bypass Input Recommended conduit and cable sizes-Module Output Recommended conduit and cable sizes-Module Bypass InputRecommended conduit and cable sizes-Load Output Recommended conduit and cable sizes-Load Bank Output#4/0 AWG Recommended lug sizesSpecifications Page Iti Ne tTi n That