Emerson ATCA-7350 manual Setup SOL Session, Query the Configuration of SOL

Setup SOL Session SOL Module Configuration

The value of Parameter selector is 1.

See table 26-5 in section 26.3 of the IPMI 2.0 specification.

On Emerson shelf manager, enable the SOL of channel 1.

ipmicmd -k "0 90 0 0c 21 01 01 01" smi 0

4.4Setup SOL Session

After the previous seven steps, you can set up a session or an SOL connection to the IPMC through IPMITOOL. You can use the commands provided by IPMITOOL to directly configure the SOL for the IPMC.

If a shelf manager supports automatic configuration through the script, you can use the script to configure the SOL directly. For example, in the command line of Emerson shelf manager, run the commands sv_stop and sv_start to restart the script and configure the SOL automatically. After that, you can use the SOL without configuring and modifying it.

4.5Query the Configuration of SOL

Querying the configuration of SOL

To query the configurations, do the following:

1.Query the IP address.

Use the command Get LAN Configuration Parameters. See table 23-3 in section 23.2 of the IPMI 2.0 specification. The value of Parameter selector is 3.

For example, on Emerson shelf manager, query the IP address of channel 1. ipmicmd -k "0 90 0 0c 02 01 03 00 00" smi 0

"90" is the IPMB address of the blade.

2.Query the subnet mask.

Use the command Get LAN Configuration Parameters. The value of Parameter selector is 6.

For example, on Emerson shelf manager, query the subnet mask of channel 1. ipmicmd -k "0 90 0 0c 02 01 06 00 00" smi 0

3.Query the user name.

Use the command Get User Name.

See table 22-33 in section 22.29 of the IPMI 2.0 specification.

For example, on Emerson shelf manager, query the name of the user 2. ipmicmd -k "0 90 0 06 46 02 " smi 0

4.Query the channel information.

Use the command Get Channel Access.

ATCA-7350 Control via IPMI Programmer’s Reference (6806800H29E) 55