Emerson Specific CommandsSupported Commands
Table 2-14 Supported PICMG 3.0 Commands (continued)
| NetFn |
|
|
Command | (Request/Response) | CMD | Comments |
|
|
|
|
Activate firmware | 0x2C/0x2D | 0x35 | - |
|
|
|
|
Query | 0x2C/0x2D | 0x36 | - |
|
|
|
|
Query rollback status | 0x2C/0x2D | 0x37 | - |
|
|
|
|
Initiate manual rollback | 0x2C/0x2D | 0x38 | - |
|
|
|
|
The firmware upgrade commands supported by the
2.3Emerson Specific Commands
The Emerson IPMC supports several commands which are not defined in the IPMI or PICMG 3.0 specification but are introduced by Emerson: serial output commands.
zBefore sending any of these commands, the shelf management software must check whether the receiving IPMI controller supports Emerson specific IPMI commands, by using the IPMI command 'Get Device ID'. Sending Emerson specific commands to IPMI controllers which do not support these IPMI commands will lead to no or undefined results.
zImplementing any of the Emerson specific IPMI commands means that the software
is not portable to other IPMI controllers that do not use the IPMC firmware.
2.3.1Serial Output Commands
Table 2-15 Serial Output Commands
Command Name | NetFn (Request/Response) | CMD | Description |
|
|
|
|
Set Serial Output | 0x2E/0x2F | 0x15 | See Set Serial Output Command on |
|
|
| page 24 |
|
|
|
|
Get Serial Output | 0x2E/0x2F | 0x16 | See Get Serial Output Command on |
|
|
| page 24 |
|
|
|
|
23 |