Emerson ATCA-7350 manual Request Data of Set Serial Output Command, Byte Data Field

Supported Commands Serial Output Commands

2.3.1.1Set Serial Output Command

The Set Serial Output command selects the serial port output source for a serial port connector.

2.3.1.1.1Request Data

The following table lists the request data applicable to the Set Serial Output command.

Table 2-16 Request Data of Set Serial Output Command

Byte	Data Field
1	LSB of Emerson IANA Enterprise number. A value of 0xCD has to be used.
2	Second byte of Emerson IANA Enterprise number. A value of 0x65 has to be used.
3	MSB of Emerson IANA Enterprise number. A value of 0x00 has to be used.
4	Serial connector type
	0: Face plate connector
	All other values are reserved.
5	Serial connector instance number. A sequential number that starts from 0.
6	Serial output selector
	0: payload serial console (default 9600 baud)
	2: IPMC(default baud rate 115200 baud)
	All other values are reserved.

2.3.1.1.2Response Data

The following table lists the response data applicable to the Set Serial Output command.

Table 2-17 Response Data of Set Serial Output Command

Byte	Data Field
1	Completion code
2	LSB of Emerson IANA Enterprise number.
3	Second byte of Emerson IANA Enterprise number.
4	MSB of Emerson IANA Enterprise number.

2.3.1.2Get Serial Output Command

The Get Serial Output Command provides a way to determine which serial output source goes to a particular serial port connector.

24 ATCA-7350 Control via IPMI Programmer’s Reference (6806800H29E)