Primera Technology LX200 user manual Sensor Type, Output Mode

Page 32

TOC

INDEX

Sensor Type

Sensor Type refers to the method the printer will use to detect the print starting position for each label. If you are using standard die-cut labels or Through-hole label material where a hole is punched through each label for alignment purposes use the Through-hole/Die-Cutsetting. Use Reflective for black stripe sensing label material where a pre-printed line on the back of the label stock indicates the break between labels. If you have continuous stock with no die-cut, reflective mark or holes set the sensor type to Continuous Feed. This will turn off the stock sensor.

Output Mode

Do not present (use with Rewinder). The label stock does not move after the last label is printed. This means that part of the last label printed is still in the printer. This should be used only if you have a label rewinder attached.

Present (Default). This setting will cause the printer to feed the last label printed forward so that it and the previously printed labels can be torn off using the tear bar. This will occur only if there are no other print jobs in queue.

Cut (using optional cutter). Use this setting only if you have the label cutter attachment (Primera Part # 074263)

28Printing Using a PC

Image 32
Contents Label Printer All rights reservedPrinting History Table of Contents Interactive Feature in this Choosing a Good Location Getting StartedThank YOU… Unpacking and Inspection Starter roll of high gloss label stockIdentifying the Parts Computer Specifications Minimum PC SpecificationsHardware and Software Setup Installing the PC SoftwareConnecting Power Connecting the USB Cable / Installing the Printer DriverTOC Installing Label Stock Throat Guide Adjusting the Label Stock TOF TOP of Form Sensor Circular LabelsThrough Hole Labels Using FAN-FOLD Label Stock Click Change Cartridge Installing the INK CartridgeClick StartPrinters and Faxes Aligning the INK Cartridge TOC Creating a label Printing Using a PCUsing Nicelabel TOC TOC TOC TOC TOC Creating Barcodes in Nicelabel RSS TOC Printer Driver Settings To find Driver SettingsPaper Size OrientationPortrait Landscape Print QualityClean/Change Cartridge & Check Ink Levels Clean/PurgeInk Saturation Cartridge AlignmentChange Cartridge Details/Print CounterOutput Mode Sensor TypeLeft Margin Offset Enable Bi-di PrintingOffsets Cut Position Top of Form TOFTear Off Position Solving Registration Problems Image is Vertically OffsetImage is printing horizontally offset TOC Creating a Full Bleed Print Cleaning the Printer Clearing a Label JAMSource Location Cleaning the INK CartridgeTechnical Support Label and Roll Specifications Method 2 Thru-Hole SensingIndex Technical Specifications Index Barcode Wizard 17, 18 Cartridge Alignment