Primera Technology LX200 user manual Enable Bi-di Printing, Offsets, Left Margin Offset

Page 33

TOC

INDEX

Enable Bi-di Printing

This setting defaults to Yes for fastest printing. When enabled you will be required to perform an alignment print after a new cartridge is installed.

Offsets

If your label is printing horizontally or vertically offset (printing on the liner or with white space left on the label) use these offset setting to adjust the position of the print on the label. Click Offsets... to reveal the properties button. Click Properties. The following screen will appear. Refer to the diagram to determine which direction to move the image, tear off position or cut position.

Left Margin Offset

This will be factory calibrated. If fine tuning is needed, increase this setting to move the image right on the label; decrease this setting to move the image to the left on the label. The unit of measure is 0.1mm.

Printing Using a PC 29

Image 33

Contents All rights reserved Label PrinterPrinting History Table of Contents Interactive Feature in this Getting Started Thank YOU…Choosing a Good Location Starter roll of high gloss label stock Unpacking and InspectionIdentifying the Parts Minimum PC Specifications Computer SpecificationsInstalling the PC Software Hardware and Software SetupConnecting Power Connecting the USB Cable / Installing the Printer DriverTOC Installing Label Stock Throat Guide Circular Labels Adjusting the Label Stock TOF TOP of Form SensorThrough Hole Labels Using FAN-FOLD Label Stock Installing the INK Cartridge Click StartPrinters and FaxesClick Change Cartridge Aligning the INK Cartridge TOC Printing Using a PC Using NicelabelCreating a label TOC TOC TOC TOC TOC Creating Barcodes in Nicelabel RSS TOC To find Driver Settings Printer Driver SettingsOrientation Paper SizePortrait Landscape Print QualityClean/Purge Clean/Change Cartridge & Check Ink LevelsInk Saturation Cartridge AlignmentDetails/Print Counter Change CartridgeSensor Type Output ModeEnable Bi-di Printing OffsetsLeft Margin Offset Top of Form TOF Tear Off PositionCut Position Image is Vertically Offset Solving Registration ProblemsImage is printing horizontally offset TOC Creating a Full Bleed Print Clearing a Label JAM Cleaning the PrinterCleaning the INK Cartridge Technical SupportSource Location Method 2 Thru-Hole Sensing Label and Roll SpecificationsIndex Technical Specifications Barcode Wizard 17, 18 Cartridge Alignment Index