Primera Technology LX200 user manual Label and Roll Specifications, Method 2 Thru-Hole Sensing

Page 41

TOC

INDEX

Section 5: Label and Roll

Specifications

Label Sensing Methods

Method 1: Label

Gap Sensing

Method 2: Thru-Hole Sensing

Method 3: Reflective/Black Mark Sensing

(Black Mark must be printed on back side of label stock)

Label Width
Liner Width
	Gap Between
	Labels
Distance from
edge of Media
Width of Opening
Distance from	Label Height
edge of Media
to edge of Label
	Black Mark
	Width

Note: See table below for Max and Min values in inches and mm..

	Max	Min
Label/Print width	4.25" (108mm)	0.75" (19mm)

Liner width	4.25" (108mm)	1" (25.4mm)

Label height/length	24" (609.6mm)	0.75" (19mm)

Gap between labels	0.75" (19mm)	0.10 (2.5mm)

Width of thru-hole	0.5" (12.7mm)	0.375 (9.5mm)
opening

Label and Roll Specifications 37

Image 41

Contents All rights reserved Label PrinterPrinting History Table of Contents Interactive Feature in this Choosing a Good Location Getting StartedThank YOU… Starter roll of high gloss label stock Unpacking and InspectionIdentifying the Parts Minimum PC Specifications Computer SpecificationsInstalling the PC Software Hardware and Software SetupConnecting Power Connecting the USB Cable / Installing the Printer DriverTOC Installing Label Stock Throat Guide Circular Labels Adjusting the Label Stock TOF TOP of Form SensorThrough Hole Labels Using FAN-FOLD Label Stock Click Change Cartridge Installing the INK CartridgeClick StartPrinters and Faxes Aligning the INK Cartridge TOC Creating a label Printing Using a PCUsing Nicelabel TOC TOC TOC TOC TOC Creating Barcodes in Nicelabel RSS TOC To find Driver Settings Printer Driver SettingsOrientation Paper SizePortrait Landscape Print QualityClean/Purge Clean/Change Cartridge & Check Ink LevelsInk Saturation Cartridge AlignmentDetails/Print Counter Change CartridgeSensor Type Output ModeLeft Margin Offset Enable Bi-di PrintingOffsets Cut Position Top of Form TOFTear Off Position Image is Vertically Offset Solving Registration ProblemsImage is printing horizontally offset TOC Creating a Full Bleed Print Clearing a Label JAM Cleaning the PrinterSource Location Cleaning the INK CartridgeTechnical Support Method 2 Thru-Hole Sensing Label and Roll SpecificationsIndex Technical Specifications Barcode Wizard 17, 18 Cartridge Alignment Index