Primera Technology LX200 user manual Clearing a Label JAM, Cleaning the Printer

Page 39

TOC

INDEX

C. CLEARING A LABEL JAM

If there is a label jam in the printer mechanism first attempt to remove the jam by opening the cover and removing the jam from the printer feed output area.

If the jam can not be located, it is possible to remove a cover over the feed input area. Pull on the center of the cover as shown below to release the tabs on the sides.

To prevent future jams, use rubbing alcohol to remove an adhesive left in the printer feed area.

D. CLEANING THE PRINTER

If any ink has gotten on to the printer casing itself, the case of the printer can be cleaned with an ammonia based window cleaner and a lint-free cloth.

Over time, ink overspray may gather at the base of the printer. The printer is designed using a vacuum system to gather most of this ink on a series of saturation pads. Eventually, these pads may need to be replaced. Contact tech support to determine if pad replacement is necessary.

Troubleshooting 35

Image 39

Contents All rights reserved Label PrinterPrinting History Table of Contents Interactive Feature in this Getting Started Thank YOU…Choosing a Good Location Starter roll of high gloss label stock Unpacking and InspectionIdentifying the Parts Minimum PC Specifications Computer SpecificationsConnecting the USB Cable / Installing the Printer Driver Hardware and Software SetupInstalling the PC Software Connecting PowerTOC Installing Label Stock Throat Guide Circular Labels Adjusting the Label Stock TOF TOP of Form SensorThrough Hole Labels Using FAN-FOLD Label Stock Installing the INK Cartridge Click StartPrinters and FaxesClick Change Cartridge Aligning the INK Cartridge TOC Printing Using a PC Using NicelabelCreating a label TOC TOC TOC TOC TOC Creating Barcodes in Nicelabel RSS TOC To find Driver Settings Printer Driver SettingsPrint Quality Paper SizeOrientation Portrait LandscapeCartridge Alignment Clean/Change Cartridge & Check Ink LevelsClean/Purge Ink SaturationDetails/Print Counter Change CartridgeSensor Type Output ModeEnable Bi-di Printing OffsetsLeft Margin Offset Top of Form TOF Tear Off PositionCut Position Image is Vertically Offset Solving Registration ProblemsImage is printing horizontally offset TOC Creating a Full Bleed Print Clearing a Label JAM Cleaning the PrinterCleaning the INK Cartridge Technical SupportSource Location Method 2 Thru-Hole Sensing Label and Roll SpecificationsIndex Technical Specifications Barcode Wizard 17, 18 Cartridge Alignment Index