TOC |
|
| INDEX |
| ||
|
|
|
|
|
|
|
|
|
| Max |
| Min |
|
|
|
|
|
|
|
|
|
| Distance from edge of | 1.90" (48.3mm) |
| 0.20" (5.1mm) |
|
|
| media to edge of |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
| Reflective/Black | Equal to distance |
| 0.10" (2.5mm) |
|
|
| Mark Width* | between labels |
|
|
|
|
| Max Outer Diameter (OD) | 5.0"(127mm) |
| N/A |
|
|
| Inner Core Diameter (ID) | see roll specifications below |
| ||
|
|
|
|
|
|
|
|
| Stock Thickness | .006” |
| N/A |
|
|
|
| (152 micron) |
|
|
|
|
|
|
|
|
| |
|
| Distance from edge of | Printer driver assumes 2 mm gap. |
| ||
|
| media to edge of label | However, this is adjustable via the |
| ||
|
|
| left margin offset. |
|
| |
*The Reflective/Black Mark should be opaque to infared light. The mark should be between the labels. The end of the mark should correspond with the beginning of the label.
Roll Specifications
Label Side Out
Roll O.D. | Label Stock |
|
2” | 5” |
Core I.D.
Core O.D.
Notes:
1.Label height <1.5” requires a 2.00” I.D. x 3.00” O.D. core. Label height >1.5” requires a 2.00” I.D. x 2.25” O.D. core.
2.Turret glue or
3.End face of liner must align with end of core on both sides within 0.030”. (Core width should be the same as liner width.)
4.Masking tape or equivalent may be used to secure label stock to outside of roll.
38Label and Roll Specifications