Primera Technology RX900 user manual Left margin offset

TOC			INDEX
		Max	Min
	Label width	8.25" (209mm)	0.75" (19mm)
	Liner/media width	8.375" (212mm)	1.5" (38mm)
	Label height/length	17" (431mm)	0.75" (19mm)
	Gap between labels	10" (253mm)	0.10" (2.5mm)
	Width of thru-hole	0.5" (12.65mm)	0.25" (6.325mm)
	opening
	Distance from edge of	2.25" (57mm)	0.20" (5.06mm)
	media to edge of
	thru-hole
	Reflective/Black	N/A	0.1" (2.54mm)
	Mark Width*
	Max Outer Diameter (OD)	6.0" (152.4mm)	N/A
	Inner Core Diameter (ID)	3.0" (76.2mm)	3.0" (76.2mm)
	Total Thickness	.0075”	N/A
	(Liner + Label)**	(7.5 mil)
	Distance from edge of	Printer driver assumes 2 mm gap.
	media to edge of label	However, this is adjustable via the
		left margin offset.

*The Reflective/Black Mark should be opaque to infared light. The mark should be between the labels. The end of the mark should correspond with the beginning of the label.

**There are two factors that determine whether the printer will accept any particular stock thickness.

1.The ability for the printer to pull the paper through the print area.

2.The ability for the sensor to read through the backing if the sensor is set to diecut.

If you are printing in continuous or reflective label sensing mode number 2 does not apply. The fact that the printer must read through the backing in die-cut mode will limit the thickness much more than the printers ability to pull the paper through the print area. However, if you adjust opacity level of the liner enough to allow the label to be seen by the stock sensor, the thickness will only be limited by the printers ability to pull it through the printer area. For these reasons the weight or thickness of the liner is a variable that can not easily be defined. Primera recommends and uses 40# liner with all label stock.

It is important to test all label stock with the intended printer before ordering large quantities!

Label Stock 7