Primera Technology RX900 user manual SET the Output Mode

Page 19

TOC

INDEX

Continuous. (Sensor off) If you have continuous stock with no die-cut, reflective mark or holes, set the sensor type to Continuous. This will turn off the stock sensor. It this mode there is no way to set the print starting position. The printer will simply start printing the first label and print each subse- quent label immediately after that previous one. To produce a gap between prints simply add the desired amount of white space to the end of the label being printed.

Important Note: You must also set the Stock Sensor Position (Section 2C) so that the sensor is sensing the correct point on the label stock.

E: SET THE OUTPUT MODE

Toggle the Output Mode to set whether or not the last label printed will be presented or left inside the printer. To adjust the output mode, open the PTStatus program. PTStatus auto- matically installs with your printer driver and can be accessed through the printer driver or as program that is accessible in the same manner as all other programs.

1.Connect the printer via USB and turn on the power. The Output Mode Setting is stored on printer main board so you will not be able to access it unless the printer is turned on and properly communicating with the computer.

2.Go to Start - Programs - Primera Technology - PTStatus.

3.Click on the Alignment Tab (3rd tab from top).

4.Click on the Output Mode button.

5.Select the Output Mode by clicking on the corresponding graphic.

Label Stock 15

Page 18 Page 20
Image 19
Page 18 Page 20
Contents 021711-511287 All rights reserved Interactive Feature Table of Contents Page Thank YOU… Getting StartedChoosing a Good Location Unpacking and Inspection Identifying the Parts This illustration shows the interior of the printer Recommended PC Specifications Computer SpecificationsLabel Stock Label and Roll SpecificationsLeft margin offset Label Side Out Roll O.D Installing Label Stock Roll Guide Movable Throat Guide Fixed Throat Guide Circular Labels Adjusting the Label Stock TOF TOP of Form SensorThrough-Hole Labels SET the Stock Sensor Mode SET the Output Mode TOC Setup Using RfidSet Marker Printing and Encoding Other Functions Ink Cartridges Status Monitor Monitoring INK Levels Using the Cost Estimator Replacing INK Cartridges / LOW INK Warning TOC TOC Printing Using NicelabelTOC TOC TOC TOC TOC Creating Barcodes in Nicelabel RSS TOC Printing from Other Programs Adjusting Print Alignment TOC Creating a Full Bleed Print Printer Driver Settings To find Driver Settings Portrait Landscape Paper SizeColor Matching Ink Saturation Solving Print Alignment Problems Troubleshooting and MaintenanceImage is Vertically Offset Image is printing horizontally offset Solving Print Quality Problems Maintenance Station Color Matching and Design Tips DPI Image printed with the LX900 TOC Create a Support Report Cleaning the PrinterAutomatic method Cleaning the PrintheadReplacing the Printhead Manual methodTOC TOC Explanation Interpreting the PRINTER’S Indicator LightsSource Location Technical SupportMedia Types Section Technical SpecificationsPrinting History Battery Notice DPI IndexTOF
Top Page Image Contents